Show simple item record

dc.contributor.author
 hal.structure.identifier
GONZALEZ, Gonzalo
250023 Universidad Nacional Autónoma de México = National Autonomous University of Mexico [UNAM]
dc.contributor.author
 hal.structure.identifier
BRAHAM, Chedly
86289 Laboratoire Procédés et Ingénierie en Mécanique et Matériaux [PIMM]
dc.contributor.author
 hal.structure.identifier
LEBRUN, Jean-Lou
211916 Laboratoire Angevin de Mécanique, Procédés et InnovAtion [LAMPA]
dc.contributor.author
 hal.structure.identifier
CHASTEL, Yvan
1158 Centre de Mise en Forme des Matériaux [CEMEF]
dc.contributor.author
 hal.structure.identifier
SEILER, Wilfrid
86289 Laboratoire Procédés et Ingénierie en Mécanique et Matériaux [PIMM]
dc.contributor.author
 hal.structure.identifier
FIGUEROA, Ignacio A.
196410 Instituto de Investigaciones en Materiales (Mexico, Mexico)
dc.date.accessioned2015
dc.date.available2015
dc.date.issued2012
dc.date.submitted2015
dc.identifier.issn1345-9678
dc.identifier.urihttp://hdl.handle.net/10985/10185
dc.description.abstractThe influence of Sn on the microstructure, microstrain and grain morphology in Al–2Si–xSn samples processed by ECAP is reported and discussed. The pseudo-binary Al–xSn alloys (where x = 0, 4, 8 mass%) were produced by conventional ingot casting. Samples were characterised by X-ray diffractometry (XRD), transmission electron microscopy (TEM), dynamical mechanical analysis (DMA) and microhardness. Results showed that the initial texture was modified after several ECAP passes and the formation of subgrains were observed. The presence of Sn enhanced the tribological properties of the alloy but, the ECAP capacity for grain refining was reduced. Besides, it was also confirmed that the damping capacity and microhardness behaviour were dependent of the Sn contents.
dc.language.isoen
dc.publisherNihon Kinzoku Gakkai
dc.rightsPost-print
dc.subjectaluminium alloys
dc.subjectequal channel angular pressing
dc.subjectnanograins
dc.subjecttransmission electron microscopy
dc.subjectRietveld refinement
dc.titleMicrostructure and Texture of Al2SixSn (x = 0, 4, 8 mass%) Alloys Processed by Equal Channel Angular Pressing
dc.identifier.doi10.2320/matertrans.M2012011
dc.typdocArticle dans une revue avec comité de lecture
dc.localisationCentre de Angers
dc.localisationCentre de Paris
dc.subject.halSciences de l'ingénieur: Matériaux
dc.subject.halSciences de l'ingénieur: Mécanique
ensam.audienceInternationale
ensam.page1234-1239
ensam.journalMaterials Transactions
ensam.volume53
hal.identifierhal-01205899
hal.version1
hal.submission.permittedupdateMetadata
hal.statusaccept
dc.identifier.eissn1347-5320


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record