Experimental Analysis and Geometrical Modeling of Cutting Conditions Effect in 5 Axis Milling with Ti6Al4V Alloy

Dépôt DSpace/Manakin

Afficher la notice abrégée

dc.contributor.author PRAT, David
ensam.hal.laboratories
  127742 Laboratoire Bourguignon des Matériaux et Procédés [LaBoMaP]
dc.contributor.author FROMENTIN, Guillaume
ensam.hal.laboratories
  127742 Laboratoire Bourguignon des Matériaux et Procédés [LaBoMaP]
dc.contributor.author POULACHON, Gérard
ensam.hal.laboratories
  127742 Laboratoire Bourguignon des Matériaux et Procédés [LaBoMaP]
dc.contributor.author DUC, Emmanuel
ensam.hal.laboratories
dc.date.accessioned 2013-11-18T08:22:57Z
dc.date.available 2013-11-18T08:22:57Z
dc.date.issued 2012
dc.date.submitted 2013-11-12T20:51:31Z
dc.identifier.issn 2212-8271
dc.identifier.uri http://hdl.handle.net/10985/7493
dc.description.abstract The 5 axis continuous milling is an advanced technique for free-form surfaces manufacturing. In finishing, this technique uses ball-end or hemispherical milling cutter. This type of operation for 5 axis milling allows the possibility to tilt the tool with two different angles. As a consequence, a mass of geometrical configurations exists and establishing accurate parameters is quite difficult to define. A geometrical model has been developed to find the effective cutting diameters and cutting speed on the cut and the finished surface. After an experimental validation, this study proposes an analysis of several 5 axis milling configurations in order to perform this technique. en_US
dc.language.iso en_US en_US
dc.publisher ELSEVIER en_US
dc.rights Post-print en_US
dc.subject cutting en_US
dc.subject end milling en_US
dc.subject effective diameter en_US
dc.title Experimental Analysis and Geometrical Modeling of Cutting Conditions Effect in 5 Axis Milling with Ti6Al4V Alloy en_US
ensam.hal.id hal-00905265 *
ensam.hal.status accept *
dc.typdoc Communications avec actes en_US
dc.localisation Centre de Cluny en_US
dc.subject.hal Sciences de l'ingénieur: Mécanique: Génie mécanique en_US
ensam.audience Internationale en_US
ensam.conference.title 5th CIRP Conference on High Performance Cutting en_US
ensam.conference.date 2012-06-04
ensam.country Switzerland en_US
ensam.title.proceeding Procedia CIRP en_US
ensam.page 84-89 en_US
ensam.volume 1 en_US

Fichier(s) constituant cette publication

 

Cette publication figure dans le(les) laboratoire(s) suivant(s)

Afficher la notice abrégée

Recherche


Nombre de documents dans SAM

  • 2823 documents

Lettre Diffuser la Science

Mon compte

Rapport d'activité

Aide