Structural, microstructural, and optical properties of Zn1−xMg xO thin films grown onto glass substrate by ultrasonic spray pyrolysis
Article dans une revue avec comité de lecture
Date
2015Journal
Applied physics. A, Materials science & processingRésumé
Pure and doped Zn1−xMgxO films were deposited onto glass substrate by ultrasonic spray pyrolysis technique. The variation of lattice constant and the blue shift of near-band-edge emission indicate that Zn2+ ions are successfully substituted by Mg2+ ions within ZnO lattice. At higher Mg content (x ≥ 0.21), a drastic change appears in the morphology, as a result of structural changes from wurtzite (ZnO) structure into a mixture of wurtzite and cubic (MgO) phases. FTIR study indicated the existence of distinct characteristic absorption peaks at ~442 cm−1 for Zn–O stretching mode that shifted toward the red region with the increase in Mg content. In addition to the host phonons of ZnO, one additional band was observed around 523 cm−1, presumably attributed to the Mg-related vibrational mode. The optical constants and thickness of thin films have been determined using experimental transmittance data. The luminescence intensity at 2.63 eV of Zn0.85Mg0.15O thin films was found to be approximately 13 times higher than that of pure ZnO film measured under the same excitation conditions
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lectureROGUAI, Sabrina; DJELLOUL, Abdelkader; SOUIER, T.; DAKHEL, A.A.; BOUOUDINA, M.; NOUVEAU, Corinne (Elsevier, 2014)ZnO, Zn0.95Co0.05O and Zn0.90Co0.05M0.05O (M@Al, Cd, Na, Cu) single phase films have been successfully synthesized by ultrasonic spray pyrolysis technique. Structural analysis by X-ray diffraction show that all the films ...
-
Article dans une revue avec comité de lectureAISSANI, Linda; WALOCK, Michael J.; DJEBAILI, Hamid; DJELLOUL, Ahmed Daoud; NOUVEAU, Corinne (Maney Publishing, 2015)This work aims to show the characterisation of Cr–V–N coatings, with the varied amounts of Cr and V. CrN, VN and Cr–V–N coatings were deposited onto silicon and XC100 steel substrates by reactive radio frequency magnetron ...
-
Article dans une revue avec comité de lectureDUPUY, Corinne; BENABOU, Abdelkader; SHIHAB, Sylvain; MESSAL, O.; PEYRE, Patrice; CLENET, Stephane (Elsevier, 2021)16MnCr5 steel parts were additively manufactured by laser powder bed fusion in order to investigate the effect of microstructure on electromagnetic properties. As process parameters have a direct impact on the obtained ...
-
Article dans une revue avec comité de lectureLABIDI, Chafik; FERREIRA-MARTIN, Jean-Pierre; DJOUADI, Mohamed Abdou; NOUVEAU, Corinne; COLLET, Robert (Elsevier, 2007)This study deals with the development of Chromium Aluminium Nitride (CrAlN) hard coatings (by varying the nitrogen content in the plasma, the target bias voltage, the working pressure and the deposition time) and their ...
-
Article dans une revue avec comité de lectureCHALA, Abdelouahad; DJOUADI, Mohamed Abdou; STEYER, Philippe; MILLET, Jean-Pierre; SAIED, Chahinez; AIDA, Mohammed Salah; LAMBERTIN, Michel; NOUVEAU, Corinne (Elsevier, 2006)This paper presents corrosion behaviour of duplex treated low alloy steel. Different kinds of samples were tested: non-treated, plasma nitrided, ZrBN-triode sputtered and ZrBN-duplex treated samples. The corrosion behaviour ...