Tribological Behavior of PVD Hard Coated Cutting Tools under Cryogenic Cooling Conditions
Article dans une revue avec comité de lecture
Résumé
Cryogenic assistance is used to improve machining performance and to enhance tool life under extreme contact conditions (pressure and temperature). This paper focuses on the influence of cryogenic cooling conditions using liquid nitrogen within the context of machining Ti6Al4 V with CrN-coated carbide cutting tools. Friction behavior of both CrN-coated and uncoated pins with and without cryogenic cooling were evaluated using a home-made laboratory tribometer. The adhesive and plastic friction coefficients were evaluated using a finite element model of the pin-Ti6Al4 V system through an inverse methodology. Finally, the contribution of the CrN coatings was evaluated under both cryogenic cooling and dry conditions.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Communication avec acteCHENG, Wenyu; OUTEIRO, José; COSTES, Jean-Philippe; M’SAOUBI, Rachid; KARAOUNI, Habib; DIETRICH, Stefan; MARCON, Bertrand; ROSA, Pedro (Elsevier BV, 2019)This paper deals with the determination of the constitutive model coefficients used in machining simulations. An optimization-based procedure is developed and applied to constitutive model coefficients determination of ...
-
Article dans une revue avec comité de lectureRÉGNIER, Tristan; MARCON, Bertrand; OUTEIRO, José; CROLET, Arnaud; D’ACUNTO, Alain; FROMENTIN, Guillaume (Taylor & Francis, 2019)Requirements on burr height and burr amount on machined parts are getting stricter. This leads to method development from manufacturing companies to predict burr distribution and its size along part edges. A deeper ...
-
Communication sans acteRÉGNIER, Tristan; OUTEIRO, José; MARCON, Bertrand; D'ACUNTO, Alain; CROLET, Arnaud; FROMENTIN, Guillaume (2016)Le but de cet article est d’étudier l’influence des paramètres de coupe sur la formation des bavures en coupe orthogonale. Pour ce faire, une étude en rabotage est réalisée avec des plaquettes carbures, sur un alliage ...
-
Article dans une revue avec comité de lectureLAZOGLU, Ismaïl; RAMIREZ, Christophe; AKMAL, Mohammad; MARCON, Bertrand; OUTEIRO, José; KREBS, Michael; ROSSI, Frederic; POULACHON, Gerard (Elsevier, 2017)Ti-6Al-4V is commonly used especially in aerospace and biomedical industries. This alloy is known as a difficult-to-cut material. Due to its poor thermal properties, the heat generated during machining processes traps near ...
-
Communication avec acteRÉGNIER, Tristan; OUTEIRO, José; MARCON, Bertrand; D'ACUNTO, Alain; CROLET, Arnaud; FROMENTIN, Guillaume (2016)Burr formation during parts manufacturing is a significant problem that companies try to minimise or eliminate. The present work aims to study the burr formation mechanisms in a cast aluminium alloy. Orthogonal cutting ...