Investigation of process parameter effect on anisotropic properties of 3D printed sand molds
Article dans une revue avec comité de lecture
Date
2018Journal
International Journal of Advanced Manufacturing TechnologyRésumé
The development of sand mold three-dimensional printing technologies enables the manufacturing of molds without the use of a physical model. However, the effects of the three-dimensional printing process parameters on the mold permeability and strength are not well known, leading the industries to keep old settings until castings have recurring defects. In the present work, the influence of these parameters was experimentally investigated to understand their effect on the mold strength and permeability. Cylindrical and barshaped test specimens were printed to perform, respectively, permeability and bending strength measurements. Experiments were designed to statistically quantify the individual and combined effect of these process parameters. While the binder quantity only affects the mold strength, increasing the recoater speed leads to both greater permeability and reduced strength due to the reduced sand compaction. Recommendations for optimizing some 3D printer settings are proposed to attain predefined mold properties and minimize the anisotropic behavior of the sand mold in regard to both the orientation and the position in the job box.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lectureSIVARUPAN, Tharmalingam; DARGUSCH, Matthew; EL MANSORI, Mohamed; CONIGLIO, Nicolas (Society of Manufacturing Engineers, 2020)3D printed sand molds for the casting industry play a vital role in manufacturing intricate parts from a computer model. The possibility of producing fairly significant structural castings using a small job-box 3D sand ...
-
Article dans une revue avec comité de lectureIn this work, the nano-wear-induced behavior of selective laser melting (SLM) processed commercial pure titanium was investigated under several applied loads from 1 mN to 100 mN. The dense (over 99%) commercial pure titanium ...
-
Article dans une revue avec comité de lectureSPITZ, N.; MEZGHANI, Sabeur; EL MANSORI, Mohamed; CONIGLIO, Nicolas; MONTAGNE, Alex (Elsevier, 2018)Nowadays buildings construction is performed by pouring concrete into molds called formworks that are usually prefabricated metallic modules. Defects such as stripping may possibly form during the removal of the formwork ...
-
Article dans une revue avec comité de lectureSPITZ, N.; MEZGHANI, Sabeur; EL MANSORI, Mohamed; CONIGLIO, Nicolas; MONTAGNE, Alex (Elsevier, 2018)The sticking of the concrete on metallic formworks during building construction generates many concrete wall defects. Several solutions have been proposed, among which surface lubrication and polymeric coatings are commonly ...
-
Article dans une revue avec comité de lectureThe friction of concrete on the interior skin of formworks takes place during the pouring of concrete into the molds. The present work investigates the friction of a granular material (i.e. fresh concrete) against metallic ...