Designing metallic surfaces in contact with hardening fresh concrete: A review
Article dans une revue avec comité de lecture
Date
2020Journal
Construction and Building MaterialsRésumé
Concrete, a commonly used material in the construction industry, interacts with metallic surfaces such as formwork during pouring and reinforced bar during lifespan. Formworks are designed to minimize hardened concrete adherence in order to avoid wall defects after formwork removal. In opposite, reinforced bar designs aim at maximizing their adherence to concrete for optimizing the transmission of mechanical solicitations. The present review investigates the surface properties that govern bonding of freshly poured concrete onto metallic surfaces. Identifying the underlying mechanisms of adhesion highlighted the importance of substrate characteristics (roughness, composition), concrete curing and compaction), and interfacial additives (release agents, wetting). This paper addresses the basic requirements in designing a functional surface interacting with concrete and emphasizes today challenges.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lectureSPITZ, N.; MEZGHANI, Sabeur; EL MANSORI, Mohamed; CONIGLIO, Nicolas; MONTAGNE, Alex (Elsevier, 2018)Nowadays buildings construction is performed by pouring concrete into molds called formworks that are usually prefabricated metallic modules. Defects such as stripping may possibly form during the removal of the formwork ...
-
Article dans une revue avec comité de lectureSPITZ, N.; MEZGHANI, Sabeur; EL MANSORI, Mohamed; CONIGLIO, Nicolas; MONTAGNE, Alex (Elsevier, 2018)The sticking of the concrete on metallic formworks during building construction generates many concrete wall defects. Several solutions have been proposed, among which surface lubrication and polymeric coatings are commonly ...
-
Article dans une revue avec comité de lectureThe friction of concrete on the interior skin of formworks takes place during the pouring of concrete into the molds. The present work investigates the friction of a granular material (i.e. fresh concrete) against metallic ...
-
Article dans une revue avec comité de lectureIn this work, the nano-wear-induced behavior of selective laser melting (SLM) processed commercial pure titanium was investigated under several applied loads from 1 mN to 100 mN. The dense (over 99%) commercial pure titanium ...
-
Article dans une revue avec comité de lectureThe development of sand mold three-dimensional printing technologies enables the manufacturing of molds without the use of a physical model. However, the effects of the three-dimensional printing process parameters on the ...