Surface drag analysis after Ti-6Al-4V orthogonal cutting using grid distortion
Communication avec acte
Auteur
Résumé
Surface integrity directly affects the mechanical behavior of the workpiece, which is especially relevant on fatigue behavior. To characterize the quality of the machined surface, aspects such as material damage, roughness or residual stress are considered. Measurement of the material damage of the surface is characterized in some cases as surface drag, depth of the affected machining zone, a phenomenon which takes place due to plastic strain in the surface layer caused by machining stress which could have an influence on residual stress. Surface drag measurement done with optical microscopes has relevant uncertainty. In this paper, a methodology to measure the surface drag with lower uncertainty is proposed. The method consists of measuring the deformation of a grid as a result of the machining process. The grid was created with micromilling. The method was applied to analyze the effect of feed on the surface integrity after orthogonal cutting of Ti-6Al-4V. The depth of the affected layer was measured using a 3D optical measuring device (Alicona Infinite Focus IFG4) and compared with numerical simulations and a good agreement was achieved. In comparison with optical microscope results, it can be concluded that traditional method underestimates surface drag
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lectureSELA, Andres; SOLER, Daniel; ORTIZ-DE-ZARATE, Gorka; GERMAIN, Guénaël; DUCOBU, François; ARRAZOLA, Pedro José (MDPI AG, 2021)Despite the prevalence of machining, tools and cutting conditions are often chosen based on empirical databases, which are hard to be made, and they are only valid in the range of conditions tested to develop it. Predictive ...
-
Article dans une revue avec comité de lectureSELA, Andres; ORTIZ-DE-ZARATE, Gorka; SOLER, Daniel; GERMAIN, Guénaël; ARISTIMUÑO, Patxi; ARRAZOLA, Pedro José (Elsevier BV, 2021)Finite Element Modelling used to predict machining outcomes needs to be supplied with the appropriate material thermomechanical properties which are obtained by specific testing devices and methodologies. However, these ...
-
Article dans une revue avec comité de lectureSELA, Andrés; ORTIZ-DE-ZARATE, Gorka; SOLER, Daniel; GERMAIN, Guénaël; GALLEGOS MAYORGA, Linamaria; ARRAZOLA, Pedro José (Elsevier, 2023-01-12)Nowadays, numerical models are one of the most widely used techniques to predict material performance subjected to different manufacturing processes. However, to obtain accurate predictions, these models require reliable ...
-
Communication avec acteCHAABANI, Sana; ARRAZOLA, Pedro José; AYED, Yessine; MADARIAGA, Aitor; TIDU, Albert; GERMAIN, Guénaël (Elsevier BV, 2020)Surface integrity induced by machining process affects strongly the performance of functional products, for instance, the fatigue life as well as the resistance to stress corrosion cracking. Consequently, it is relevant ...
-
Article dans une revue avec comité de lectureCHAABANI, Sana; ARRAZOLA, Pedro José; AYED, Yessine; MADARIAGA, Aitor; TIDU, Albert; GERMAIN, Guénaël (Elsevier, 2020)The most important challenges when machining difficult-to-cut alloys used in critical applications consist mainly in increasing tool life as well as improving the component surface integrity. In particular, the nickel based ...