Heat treatment simulation of Ti-6Al-4V parts produced by selective laser melting
Article dans une revue avec comité de lecture
Author
Date
2020-12-17Journal
Additive ManufacturingAbstract
The present work focuses on the simulation of the heat treatment applied after printing of Ti-6Al-4V parts. The numerical tool aims at predicting the influence of heat treatment conditions (e.g. holding time, temperature) on the residual stress field and the distortions for SLM produced parts. The numerical model relies on a thermo-viscoplastic constitutive model. To determine the corresponding material parameters, different creep tests have been performed at temperatures ranging from 723 K to 1173 K. According to the results, the stationary creep strain rate is independent of the hydrostatic pressure, which indicates that the high temperature behavior is not impacted by the initial porosity. Also, the material parameters are observed to change significantly from 873 K, which is due to the progressive transformation of the initial a' martensitic microstructure into the a+b lamellar microstructure. To validate the proposed approach, some numerical simulations have been performed for two different parts, for which distortions have been measured. The numerical and experimental distortions have then been compared to each other. For both parts, the agreement between experimental and numerical data is correct.
Files in this item
Related items
Showing items related by title, author, creator and subject.
-
Conférence invitéeYOUNES, Wael; GIRAUD, Eliane; ZOUARI, Ahmed; DAL SANTO, Philippe; VAN DER VEEN, Sjoerd (2016)Creep-age-forming of a thick Al-Cu-Li sheet is studied. An industrial stamping press is used to form a double curvature panel at a reduced scale. This forming, which includes several relaxation steps, is modelled using ...
-
Conférence invitéeYOUNES, Wael; GIRAUD, Eliane; MONTASSAR, Fredj; DAL SANTO, Philippe; VAN DER VEEN, Sjoerd (2016)Creep forming of Al-Mg-Li alloy sheets is studied. An instrumented bulging machine is used to form a double curvature panel at a reduced scale. The deformation of the work-sheet is ensured by a 7475 aluminum alloy lost ...
-
Article dans une revue avec comité de lectureDUMAS, Antoine; ECHARD, Benjamin; GAYTON, Nicolas; ROCHAT, Olivier; VAN DER VEEN, Sjoerd;
DANTAN, Jean-Yves (Elsevier, 2013)
Tolerance verification permits to check the product conformity and to verify assumptions made by the designer. For conformity assessment, the uncertainty associated with the values of the measurands must be known. In fact, ... -
Communication avec acteYOUNES, Wael; GIRAUD, Eliane; DAL SANTO, Philippe (Trans Tech Publications, 2015)Anisotropic behavior at high temperature of an Aluminum-Lithium alloy was studied. Mechanical tests at a temperature of 350°C and a strain rate of 10-2 s-1 were carried out on samples taken at different angles with respect ...
-
Conférence invitéeEL GUEDER, Jawhar; GIRAUD, Eliane; ZHAO, Nan; DAL SANTO, Philippe (2016)Cold stretching of a thin 5154 aluminium sheet is studied. An instrumented bench is developed to analyse the forming of double curvature panels. A numerical tool using ABAQUS software is developed to predict the behaviour ...