Contact Pressure Measurement System in Cross Wedge Rolling
Communication avec acte
Résumé
In the cross wedge rolling process (CWR), plastic deformation is geared by a driving torque transmitted by friction on die surface. Friction plays a role which has to be further identified in this metal forming process. The local contact pressure between a cylindrical billet and flat dies seems to be a relevant parameter to characterize the severe contact conditions during the rolling. This paper deals with an experimental measurement technology, which has been designed and implemented on a semi-industrial CWR test bench with plate configuration. This measurement system using pin and piezoelectric sensor is presented, with an analysis of the system operation and design detail. Characterization of systematic error and calibration tests are then explained. Additional tests performed on hot steel preforms allow to check the ability of the contact pressure measurement system to resist under severe operating conditions. Realistic results for varying temperatures are then discussed.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Chapitre d'ouvrage scientifiqueTill now, the definition of cross wedge rolling dies requires know-how and important expertise from the designers. A decision-making methodology is being developed to provide sequential and logical steps to draw easier and ...
-
Communication avec acteThe cross wedge rolling process is commonly used for the manufacturing of shaft or for preforms, being used for preliminary operation of forming cycle. The presence of angular deformation produced during the rolling process ...
-
Article dans une revue avec comité de lectureThe author presents an approach to study an innovative manufacturing process developed to produce composite parts with new geometrical possibilities. The aim of this first study is to understand the motions of fibers during ...
-
Cobalt-based superalloy layers deposited on X38CrMoV5 steel base metal by explosion cladding process Article dans une revue avec comité de lectureA grade 25 cobalt-based superalloy in the form of a sheet 5 mm in thickness and a steel substrate of type X38CrMoV5 are joined by explosion cladding. The macrostructure and microstructure of the interface and of the co-based ...
-
Article dans une revue avec comité de lectureThe distribution of liquid at the semi solid state is one of the most important parameters for steel thixoforging. It has a great influence on the viscosity of the material, on the flows and finally on the final shape and ...