Oxidative solution polymerization of aniline hydrochloride onto electrospun nanofibers mats of polylactic acid: Preparation method and characterization
Article dans une revue avec comité de lecture
Date
2014Journal
Journal of Applied Polymer ScienceRésumé
In this work, we present the preparation of polylactic acid (PLLA)/polyaniline (PANI) conductive composite nanofibers mats. They are prepared by bulk oxidative solution polymerization of PANI onto electrospun non-woven fibers mats of PLLA. The PANI ratio in the composite is about 70%w/w. Scanning electron microscopy (SEM) shows that PLLA nanofibers are randomly oriented, beads free with diameters of 186 ± 85 nm, The PLLA/PANI composite nanofibers diameter values are 518 ± 128 nm with a good adherence between PANI and PLLA nanofibers. DSC and XRD measurements reveal an amorphous structure of the electrospun PLLA fibers due to the rapid evaporization of the solvent. FTIR and UV-vis spectra reflect good mutual interactions between PANI and PLLA chains. The DC-conductivities (σ=0.07-0.13-S.cm-1) far better than other published ones for similar composites prepared by bulk oxidative solution polymerization of PANI onto other electrospun nanofiber mats or with electrospun nanofibers from a solution mixture of PLLA and PANI.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lectureMONTAZERI, Arash; KHAVANDI, Alireza; JAVADPOUR, Jafar; TCHARKHTCHI, Abbas (Elsevier, 2010)Along with carbon nanotubes (CNT) morphology, impurity, and functionalization, polymer curing cycle is another important factor in determining the mechanical properties of the CNT/polymer composite samples. This work ...
-
Article dans une revue avec comité de lectureBENFRIHA, Khaled; AHMADIFAR, Mohammad; SHIRINBAYAN, Mohammadali; TCHARKHTCHI, Abbas (Wiley, 2021-11)The fused filament fabrication (FFF) process of polymer-based composites has been developed due to its capability to make complex geometries and shapes with reasonable mechanical properties. However, the improvement of ...
-
Article dans une revue avec comité de lectureSHIRINBAYAN, Mohammadali; ZIRAK, Nader; SADDAOUI, Ouiza; MAMMERI, Amrid; AZZOUZ, Kamel; BENFRIHA, Khaled; TCHARKHTCHI, Abbas; FITOUSSI, Joseph (Springer Science and Business Media LLC, 2022-10)Stereolithography (SLA) is becoming an important fabrication method among the different additive manufacturing techniques. This study investigates the effect of high strain rate on mechanical behavior, considering the fact ...
-
Article dans une revue avec comité de lectureASGARPOUR, Monir; BAKIR, Farid; KHELLADI, Sofiane; KHAVANDI, Alireza; TCHARKHTCHI, Abbas (Wiley-Blackwell, 2012)During rotational molding, a loosely packed, low-density powder compact transforms into a fully densified polymer part. This transformation is a consequence of particles sintering. Powder compact density evolution of the ...
-
Article dans une revue avec comité de lectureFatigue damage initiation of a PA66/glass fiber composite material is studied with interrupted tests carried out with an “alternative bending device” and a small applied strain. During the damage initiation period, no ...