Evaluating Residual Stresses Induced by Drilling of Ti-6Al-4V Alloy by Using an Experimental-Numerical Methodology
Communication avec acte
Author
NOBRE, Joao Paulo 
MARTINS DO OUTEIRO, Jose CarlosAbstract
An experimental-numerical methodology is applied to evaluate the residual stresses induced by drilling of Ti-6Al-4V alloy. The influence of ultra-high cutting speeds on the residual stress distribution is analysed. These ultra-high cutting speeds are produced by a turbine system powered by compressed air, which are commonly used in the hole-drilling equipment for residual stress measurements. The applied hybrid methodology has demonstrated an important role on the optimization of the drilling operations parameters for an improved residual stress distribution.
Files in this item
Collections
Related items
Showing items related by title, author, creator and subject.
-
Article dans une revue avec comité de lecture; ; ;MARTINS DO OUTEIRO, Jose Carlos; ; ; (Elsevier, 2013)
Residual strains induced by drilling of glass-fibre reinforced polymers (GFRP) were determined using a hybrid experimental-numerical methodology. Experimentally, a set of GFRP specimens were drilled under well-defined ...
-
Article dans une revue avec comité de lectureMARTINS DO OUTEIRO, Jose Carlos; ; MARQUES, Maria José (Trans Tech Publications, 2014)
The major challenge of the Mg alloys has been their unsatisfactory corrosion resistance, which can be enhanced by improving the surface integrity. Cryogenic machining, where liquid nitrogen was used during machining, has ...
-
Article dans une revue avec comité de lecture; ;MARTINS DO OUTEIRO, Jose Carlos; ; ; ; ; ; (Elsevier, 2017)
This paper reviews recent advances in constitutive and friction data and models for simulation of metal machining. Phenomenological and physically-based constitutive models commonly used in machining simulations are presented ...
-
Communication avec acte; ; ;MARQUES, Maria José; MARTINS DO OUTEIRO, Jose Carlos (2008)
Machinability enhancement of hot work tool steels can be achieved intrinsically through tailoring of alloying elements and steel processing route but also externally through the use of adequate tooling. The aim of the ...
-
Communication avec acte;MARTINS DO OUTEIRO, Jose Carlos; (Elsevier, 2015)
Johnson-Cook constitutive model is still the most used model in metal cutting simulation, although several drawbacks reported in the literature. A high number of Johnson-Cook model parameters can be found in the literature ...