Nos laboratoires: Soumissions récentes
Voici les éléments 1849-1855 de 6547
-
Article dans une revue avec comité de lecture(Informa UK Limited, 2020)Orthodontic treatments are based on a prolonged application of mechanical forces on the teeth through orthodontic appliances, leading to tooth movement due to the remodeling of the surrounding bone. Bone response is dependent ...
-
Article dans une revue avec comité de lecture
MUTH-SENG, Christophe; ; ; LAPORTE, Sébastien (Elsevier, 2018)
Fascia Lata Numerical Model With Discrete Element Method: Relationship Between Micro And Macroscale For Tensile Tests Until Rupture -
Article dans une revue avec comité de lecture;CHINESTA SORIA, Francisco; ; ; (Elsevier BV, 2021)
The development of condition monitoring (CM) systems of induction machines (IMs) is essential for the industry because the early fault detection would help engineers to optimise maintenance plans. However, the use of several ...
-
Article dans une revue avec comité de lecture; ;KTARI, Ahmed (Springer Verlag, 2021)
The stainless clad steel materials (particularly A283-Gr-C hot-rolled to austenitic stainless steel plate SA240 TP 316L) have become widely used in the fabrication of heat exchangers, pressure vessels, and other components ...
-
Article dans une revue avec comité de lecture; ; ; ; ;NOUVEAU, Corinne (Research Review of sciences and technologies, 2021)
Physical vapor deposition (PVD) coatings namely Cr/CrN, Cr/ CrN / CrAlN multilayers (period of μ = 4 with a Cr bonding layer 138 nm thick), have been synthesized on a quenched and tempered X38CrMoV8 steel to test their ...
-
Communication avec acte;NGUYEN, Ngac Ky; SEMAIL, Eric (IEEE, 2021)
This paper is to propose a control scheme, a combination of the classical field-oriented control (FOC) technique and artificial intelligence (AI), to obtain constant torques in multiphase non-sinusoidal permanent magnet ...
-
Communication avec acte; ;TEREKHINA, Svetlana (IOP Publishing, 2020)
Additive manufacturing methods make it possible to create complex geometry parts, that cannot be produced by conventional methods. For manufacture of the products, composite polymeric materials can be used, both disperse-filled ...
