Experimental study of the contribution of gear tooth finishing processes to friction noise
Article dans une revue avec comité de lecture
Micro geometry of a gear tooth influences the contact durability and wear performance. In this paper, different gear tooth flanks have been manufactured by different finishing processes, which were then characterized using multiscale surface analysis, based on wavelet transform. The friction noise was then measured before and after meshing in dry and lubricated conditions, to quantify the acoustic performance of the surfaces. To accomplish this objective, a new non-destructive sensory measurement technique was developed to characterize the friction noise generated by teeth flank surface. Results show the ability of the new method to discriminate functional behavior of different surfaces as well as give possible explanations as to the contribution of tooth flank asperities during the meshing on the gear in terms of gear noise performances.
Showing items related by title, author, creator and subject.
Communication avec acteDEMIRCI, Ibrahim; MEZGHANI, Sabeur; YOUSFI, Mohammed; ZAHOUANI, Hassan; EL MANSORI, Mohamed (2013)The reduction of friction and the limitation of emissions of greenhouse gases are the main objectives of the automotive industry. This energy e ciency is related to functionalization of the surface of ringpack tribo-system. ...
Article dans une revue avec comité de lectureDEMIRCI, Ibrahim; MEZGHANI, Sabeur; YOUSFI, Mohammed; ZAHOUANI, Hassan; EL MANSORI, Mohamed (Taylor & Francis, 2012)Multistage abrasive finishing processes (grinding, polishing, honing, etc.) are commonly used to produce the geometrical properties of a surface to meet its technical functionalities in the operating characteristics of ...
Article dans des revues avec comité de lectureMEZGHANI, Sabeur; DEMIRCI, Ibrahim; ZAHOUANI, Hassan; EL MANSORI, Mohamed (Elsevier, 2012)A cylinder liner possesses fairly intricate surface requirements due to its complicated functions. It needs to provide adequate surface roughness to resist wear as well as to store and retain lubricants during high ...
Energy efficiency optimization of engine by frictional reduction of functional surfaces of cylinder ring-pack system Article dans une revue avec comité de lectureMEZGHANI, Sabeur; DEMIRCI, Ibrahim; EL MANSORI, Mohamed; ZAHOUANI, Hassan (Elsevier, 2013)Friction reduction, lower oil consumption, and limitation of greenhouse gases emissions are the chief objectives of the automotive industry in order to improve the environmental efficiency of vehicle engines. In this paper, ...
Article dans une revue avec comité de lectureJOLIVET, Simon; MEZGHANI, Sabeur; ISSELIN, Jérôme; EL MANSORI, Mohamed (Elsevier, 2016)The contribution o fgear tooth flank surface micro-finish on gear noise has not yet been taken into consideration. This paper is devoted to study the simultaneous effect of tooth roughness and lubricant viscosity on ...