Time-averaged second-order pressure and velocity measurements in a pressurized oscillating flow prime mover
Article dans une revue avec comité de lecture
Date
2016Journal
Journal of Mechanical Science and TechnologyRésumé
Nonlinear phenomena in oscillating flow devices cause the appearance of a relatively minor secondary flow known as acoustic streaming, which is superimposed on the primary oscillating flow. Knowledge of control parameters, such as the time-averaged second-order velocity and pressure, would elucidate the non-linear phenomena responsible for this part of the decrease in the system’s energetic efficiency. This paper focuses on the characterization of a travelling wave oscillating flow engine by measuring the time-averaged secondorder pressure and velocity. Laser Doppler velocimetry technique was used to measure the time-averaged second-order velocity. As streaming is a second-order phenomenon, its measurement requires specific settings especially in a pressurized device. Difficulties in obtaining the proper settings are highlighted in this study. The experiments were performed for mean pressures varying from 10 bars to 22 bars. Non-linear effect does not constantly increase with pressure.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lectureAZZAM, Tarik; PARIDAENS, Richard; OUALLI, Hamid; RAVELET, Florent; BAKIR, Farid; KHELLADI, Sofiane (SAGE Publications, 2017)In an axial fan, a leakage flow driven by a pressure gradient between the pressure side and the suction side occurs in the gap between the shroud and the casing. This leakage flow is in the opposite direction to the main ...
-
Article dans une revue avec comité de lectureLUCAS, Albert; DANLOS, Amélie; SHIRINBAYAN, Mohammadali; MOTAHARINEJAD, Vajihe; PARIDAENS, Richard; BENFRIHA, Khaled; TCHARKHTCHI, Abbas; BAKIR, Farid (Springer Verlag, 2019)n this work, the rotational molding process is developed to manufacture in one piece an axial-flow turbomachine rotor with hollow blades. Giving to our knowledge, this process has never been employed in the making of these ...
-
Article dans une revue avec comité de lectureNGUYEN, Van-Thang; ABED, Cheikh Brahim; DANLOS, Amelie; PARIDAENS, Richard; RAVELET, Florent; DELIGANT, Michael; BAKIR, Farid; KHELLADI, Sofiane (American Society of Mechanical Engineers, 2021)The present study deals with a low pressure-ratio centrifugal compressor consisting of two counter-rotating rotors called a Counter-Rotating Centrifugal Compressor (CRCC). The design method based on the loss model was ...
-
Article dans une revue avec comité de lectureMOTTA, Dario; FLAY, Richard G.J.; RICHARDS, P.J.; LE PELLEY, David; DEPARDAY, Julien; BOT, Patrick (Elsevier, 2014)An innovative method combining simultaneous on-water pressure and sail shape measurements for determining aerodynamic forces produced by sails is described and used on Stewart 34 and J80 Class yachts flying asymmetric ...
-
Communication avec acteThis paper presents a novel approach to generate online jerk-limited trajectories for multi-DOF robotic systems. Finite Impulse Response filters are used to efficiently turn low computational cost acceleration-limited ...