Laboratoire Ingénierie des fluides Systèmes énergétiques (LIFSE): Soumissions récentes
Voici les éléments 22-28 de 42
-
Numerical Prediction for Temperature Profile of Parts Manufactured using Fused Filament Fabrication Article dans une revue avec comité de lecture(Elsevier BV, 2022)Bonding of parts produced by fused filament fabrication (FFF) significantly depends on the temperature profile of filaments depositing one top of each other. It is necessary to evaluate the temperature profile during ...
-
Article dans une revue avec comité de lecture(2019)lt is a known fact that incorporating textures in the contact surfaces can significantly enhance bearing performances. The purpose of this paper is to outline the effects of texture bottom profiles and contour geometries ...
-
Article dans une revue avec comité de lecture(MDPI AG, 2021)Fused filament fabrication (FFF), an additive manufacturing technique, unlocks alternative possibilities for the production of complex geometries. In this process, the layer-by-layer deposition mechanism and several heat ...
-
Article dans une revue avec comité de lecture(American Society of Mechanical Engineers, 2021)The present study deals with a low pressure-ratio centrifugal compressor consisting of two counter-rotating rotors called a Counter-Rotating Centrifugal Compressor (CRCC). The design method based on the loss model was ...
-
Article dans une revue avec comité de lecture(MDPI AG, 2020)The present study focuses on the inception, the growth, and the potential unsteady dynamics of attached vapor cavities into laminar separation bubbles. A viscous silicon oil has been used in a Venturi geometry to explore ...
-
Article dans une revue avec comité de lecture(Wiley, 2020)Fused filament fabrication (FFF), an additive manufacturing technique, is used to produce prototypes and a gradually more important processing route to get final products. Due to the layer-by-layer deposition mechanism ...
-
Article dans une revue avec comité de lecture(Springer Verlag, 2021)Nowadays, polyamide 12 (PA-12) is considered as an interesting polymer in the rotomolding process to manufacture different pieces like the liner part in the storage hydrogen tank (type IV). In this study, the pure polyamide-12 ...