Laboratoire d'Electrotechnique et d'Electronique de Puissance (L2EP) de Lille: Soumissions récentes
Voici les éléments 8-14 de 326
-
Article dans une revue avec comité de lecture(Elsevier BV, 2024-04-30)This work presents an innovative non destructive control process in order to guide for the end of life (re-use or recycling) of permanents magnets (PM) rotors of electric motors. The process is based on the measurement of ...
-
Communication avec acte(Verlag Der Technischen Universität Graz, 2016-09)Magnetic parts are usually composed of a stack of electrical steel laminations to reduce the eddy current losses. However, for cost reasons or for specific applications the magnetic core can be made from massive steel and ...
-
Conférence invitée(2022-10)One major challenge of e-aerospace motor is high densities (kW/kg, Nm/kg) keeping a high functional reliability. With high switching frequency Voltage Source Inverter (VSI) using Wide-Band Gap (WBG) components, the DC-bus ...
-
Communication avec acte(IEEE, 2023-08)T-type multilevel inverters are a potential alternative because of their increased efficiency and low conduction losses. T-Type topology is formed by adding a bidirectional switch to a conventional two-level inverter. There ...
-
Article dans une revue avec comité de lecture(Elsevier BV, 2023-12)In order to improve the driving performance of electric vehicles (EV), a permanent magnet synchronous motor with double V-shaped magnet structure (DVMPMSM) and its driving system are studied in this paper. A 150kW DVMPMSM ...
-
Article dans une revue avec comité de lecture(International Information and Engineering Technology Association, 2021-12)This paper proposes a sensorless control strategy based on Sliding Mode Observer (SMO) for a Five-phase Interior Permanent Magnet Synchronous Machine (FIPMSM), with a consideration of the third harmonic component. Compared ...
-
Communication avec acte(IEEE, 2022-09)For in-wheel machine, outer rotor machines appear as a natural solution. Practically these machines are either radial-flux with one rotor or axial-flux with two rotors. The paper is proposing a machine with three outer ...