Laboratoire Bourguignon des Matériaux et Procédés (LaBoMaP)

Browse by

Authors Issue Date Center / Institution Hal Status

Usinage grande vitesse avec maîtrise globale du procédé appliqué aux matériaux difficiles et surfaces complexes Usinage et mise en forme du bois Traitements superficiels et optimisation des matériaux et alliages.
Plus d'informations sur le site du LaBoMaP :
labomap.ensam.eu

Recent Submissions

Machining simulation of Ti6Al4V using coupled Eulerian-Lagrangian approach and a constitutive model considering the state of stress

XU, Xiang; OUTEIRO, José; ZHANG, Jun; XU, Binbin; ZHAO, Wanhua; ASTAKHOV, Viktor (Elsevier, 2021)

The accuracy of a machining model depends on the capability of this model to describe the physical phenomena associated to the real machining system. This includes the material constitutive model and the approach used to ...
Effects of plasma nitriding on low alloy Cr-Mo-V steel

TRINADH, Kalimi; NOUVEAU, Corinne; RAO, K. Ram Mohan (Elsevier BV, 2021)

In this study the effects on resistance to corrosion of a low alloy steel after plasma nitriding has been reported. Nitriding was performed at a low temperature of 450 °C and also at 520 °C for the same duration of 10 h ...
Generalized cutting force model for peripheral milling of wood, based on the effect of density, uncut chip cross section, grain orientation and tool helix angle

CURTI, Rémi; MARCON, Bertand; DENAUD, Louis; TOGNI, Marco; FURFERI, Rocco; GOLI, Giacomo (Springer, 2021)

The influence of the grain angle on the cutting force when milling wood is not yet detailed, apart from particular cases (end-grain, parallel to the grain, or in some rare cases 45°-cut). Thus, setting-up wood machining ...
New mechanistic cutting force model for milling additive manufactured Inconel 718 considering effects of tool wear evolution and actual tool geometry

DUCROUX, Edouard; FROMENTIN, Guillaume; VIPREY, Fabien; PRAT, David; D’ACUNTO, Alain (Elsevier BV, 2021)

Inconel 718 is widely used in aircraft industry due to its properties. Nevertheless, its mechanical and chemical properties make it hard-to-cut. As a consequence, additive manufacturing is developed in order to get near ...
Mechanical and Tribological Behaviors of Nanocomposite Titanium Nitrides Coatings

BELGROUNE, Ahlam; AISSANI, Linda; SALHI, Faiza; NOUVEAU, Corinne; ALHUSSEIN, Akram (Trans Tech Publications, 2021)

TiN coatings with a thickness of 2 μm were deposited using the magnetron sputtering has developed rapidly over the last decade in such a way that it has become an established process of choice for the deposition of a wide ...
Low-temperature plasma nitriding of martensitic stainless steel

RAO, K. Ram Mohan; NOUVEAU, Corinne; TRINADH, Kalimi (Springer, 2020)

This study presents the plasma nitriding of Cr–Mo–V tool steel to protect it from environmental degradation. The steel samples after metallographic polishing were nitrided in the glow discharge plasma of N2 and H2 gas ...
Elevated temperature plasma nitriding and effects on electrochemical properties of steel

RAO, K. Ram Mohan; TRINADH, Kalimi; NOUVEAU, Corinne (Elsevier BV, 2019)

Surface modification of tool steel had been performed by utilizing plasma nitriding at elevated temperature by varying the exposure time. The nitrided steel had shown significantly enhanced corrosion resistance properties. ...