Laboratoire Procédés et Ingénierie en Mécanique et Matériaux (PIMM): Soumissions récentes

Voici les éléments 708-714 de 1243

    • A Mullins softening criterion for general loading conditions 
      Article dans une revue avec comité de lecture
      MERCKEL, Yannick; BRIEU, Mathias; DIANI, Julie; CAILLARD, Julien (Elsevier, 2012)
      Samples of carbon-black filled styrene butadiene rubbers (SBRs) were submitted to successive nonproportional loadings in order to define a general criterion for the Mullins softening. For this purpose, each sample was ...
    • Study of laser interaction in water flow confinement at high repetition rate 
      Article dans une revue avec comité de lecture
      BERTHE, Laurent; COURAPIED, Damien; EL KARNIGHI, Samy; PEYRE, Patrice; GORNY, Cyril; ROUCHAUSSE, Yann (Laser Institute of America, 2017)
      This paper presents a study on the confined interaction with water flow for two successive laser pulses. The dynamic of the renewal of water films after shock produced by the laser is observed using a high speed camera. ...
    • Rheokinetic of polyurethane crosslinking time-temperature-transformation diagram for rotational molding 
      Article dans une revue avec comité de lecture
      FARZANEH, Sedigheh; RIVIERE, Sylvain; ccTCHARKHTCHI, Abbas (Wiley, 2012)
      In this work, the rheokinetic of polyurethane crosslinking was studied by different methods: differential scanning calorimetric (DSC), rheometry, and infrared spectrometry. The conversion ratio and the glass transition ...
    • About the effect of plastic dissipation in heat at the crack tip on the stress intensity factor under cyclic loading 
      Article dans une revue avec comité de lecture
      ccPALIN-LUC, Thierry; PARIS, Paul Croce; ccRANC, Nicolas; ccSAINTIER, Nicolas (Elsevier, 2014)
      Because of the reverse cyclic plastic zone at the crack tip, there is plastic dissipation in heat at the crack tip under cyclic loading. That creates a heterogeneous temperature field around the crack tip. A thermomechanical ...
    • Dissipation in hysteretic rubber mount models 
      Communication avec acte
      PENAS, Rafael; GAUDIN, Arnaud; KREIS, Adrien; BALMES, Etienne (2019)
      Rubber mounts are elements of extreme importance in automotive suspension, and accurate modeling is crucial for comfort design. While mount characterization is typically done using cycles, actual performance is often ...
    • Thermal Ageing of a Hybrid Composite Rod for Next Generation Overhead Power Lines 
      Article dans une revue avec comité de lecture
      MINARD, Gaelle; ccCOLIN, Xavier (MDPI, 2019)
      The thermal stability of a hybrid composite rod, made of epoxy-anhydride matrix reinforced with both unidirectional carbon and glass fibers, has been evaluated between 180 and 210 °C in different nitrogen/oxygen gas mixtures ...
    • Thermal oxidation of Poly(dicyclopentadiene)– kinetic modeling of double bond consumption 
      Article dans une revue avec comité de lecture
      HUANG, Jing; DAVID, Adelina; LE GAC, Pierre-Yves; LORTHIOIR, Cédric; COELHO, Cristina; ccRICHAUD, Emmanuel (Elsevier, 2019)
      This paper reports chemical changes that occur in polydicyclopentadiene during thermal oxidation at several temperatures and oxygen pressures. A particular attention was paid to the double bond consumption since these ...