Laboratoire Procédés et Ingénierie en Mécanique et Matériaux (PIMM): Soumissions récentes
Voici les éléments 1289-1295 de 1328
-
Article dans une revue avec comité de lecture; ;
FAYOLLE, Bruno (Elsevier, 2009)
The Mullins’ effect remains a major challenge in order to provide good mechanical modeling of the complex behavior of industrial rubber materials. It’s been forty years since Mullins [1] wrote his review on the phenomenon ... -
Article dans une revue avec comité de lecture; ; ; ; ; ;REGNIER, Gilles (Wiley, 2012)
Multilayered film polycarbonate/polystyrene (PC/PS) comprising 257 layers with total thickness 125 m was made by coextrusion process. The nominal thickness of PC layers was 680 nm, and the nominal thickness of PS layers ...
-
Article dans une revue avec comité de lecture(Elsevier, 2013)Micromechanics modeling of the linear viscoelasticity of carbon-black filled styrene butadiene rubbers (SBR) shows that a simple representation of a spherical rigid-phase surrounded by rubber gum and embedded in an homogeneous ...
-
Article dans une revue avec comité de lecture; ;FAYOLLE, Bruno (Springer Verlag, 2010)
Polyurethane networks have been prepared from a mix of tri- and quadriisocyanate and from two types of diols, polyether-based (with molar masses of 1,000, 2,000, and 4,000 g/mol) and polyester-based (1,035 g/mol). The ...
-
Article dans une revue avec comité de lecture(Laser Institute of America, 2012)In laser cutting of thick steel sheets, quality difference is observed between cut surfaces obtained with 1 micron and 10 micron laser beams. This paper investigates physical mechanisms for this interesting and important ...
-
Article dans une revue avec comité de lectureRICHAUD, Emmanuel (Elsevier, 2013)
Irganox 1010 stabilized PE was monitored by carbonyl build-up and DSC under oxygen. A scheme for PE stabilization by phenols was implemented and its kinetic parameters were calculated from experimental results. This model ...
-
Article dans une revue avec comité de lecture(Laser Institute of America, 2012)Derived from laser cladding, the Direct Laser Metal Deposition (DLMD) process is based upon a laser beam – powder – melt pool interaction, and enables the manufacturing of complex 3D shapes much faster than conventional ...
