Simulation and measurement of residual stress and warpage in a HgCdTe-based infrared detector at 100 K
Article dans une revue avec comité de lecture
Date
2021Journal
Materials Science and Engineering: AAbstract
A thermomechanical analysis on a 320 × 256, 30 μm pitch, middle wave infrared detector operating at 100 K is conducted. The stress induced in the HgCdTe single crystal layer needs to be minimized to avoid electro-optical perturbations and the planarity of the detector has to respect strict optical requirements. The work includes stress determination by X-ray-diffraction (XRD), warpage measurements with laser scanning, analytical calculation and finite-element modelling. The hybridized detector is studied both alone and after being glued to an AlN hosting substrate. The results show that the initial stress in HgCdTe at room temperature is biaxial for all samples, with either tensile or compressive values (±10 MPa), mainly due to the lattice mismatch during epitaxy from CdZnTe. A stress increase of +45 MPa is induced after cooling to 100 K, with a maximum value of 57 MPa. The warpage of the hybridized circuit is then about 2.5 μm and is reduced after being glued to the hosting substrate. Finally, the model is used to extrapolate the behavior of such a detector for larger formats until 2 K2; there is no significant impact on the stress in the HgCdTe layer, but warpage increases proportionally to the squared diagonal of the detector.
Files in this item
Related items
Showing items related by title, author, creator and subject.
-
Micromachine d'essais mécaniques de type traction et compression ayant une accessibilité optimisée BrevetBOMONT, Olivier; WARY, Marc; BIANCHIN, Jeremy; SIMON, Lionel; BOEHM, Daniel; HECKER, Jean-Michel; PEIFFERT, Xavier; PESCI, Raphaël (2015)L'invention concerne une micromachine de traction destinée à être utilisée dans une enceinte de microscope électronique à balayage ou avec un appareil de diffraction, comportant deux mors (1) portés par deux supports, ...
-
Article dans une revue avec comité de lectureINAL, Karim; LEBRUN, Jean-Lou; DIARD, Olivier; MASSON, Renaud; PESCI, Raphaël (Wiley-Blackwell, 2006)Stress analyses by X-ray diffraction are performed on a cast duplex (32% ferrite) stainless steel elbow and a bainitic (95% ferrite) pressure vessel steel. During an in situ tensile test, micrographic observations are made ...
-
Conférence invitéeA specific in-situ tensile device has been set up in an X-Ray diffractometer. Stress can be measured at low temperature during loading in the baintic steel and in the ferritic phase. A two-scale modeling has been proposed ...
-
Article dans une revue avec comité de lectureTAUPIN, Vincent; BERBENNI, Stéphane; OUAHAB, Razane; BOUAZIZ, Olivier; BERVEILLER, Sophie; PESCI, Raphaël (Elsevier, 2013)In situ tensile tests were performed at room temperature on a ferrite–cementite steel specifically designed for this study. The evolution of the average stress in ferrite during loading was analyzed by X-ray diffraction.Lattice ...
-
Article dans une revue avec comité de lectureDESBORDES, Cloé; PESCI, Raphaël; PIOTROWSKI, Boris; MAILLIART, Olivier; RAPHOZ, Natacha (Elsevier BV, 2024-10)Flip-chip assembly of photonic components can be achieved at room temperature by using 10 μm pitch interconnects made of metallised oxide microtubes inserted into ductile reception pads. In order to reduce the electrical ...