• français
    • English
    English
  • Ouvrir une session
Aide
Voir le document 
  •   Accueil de SAM
  • Laboratoire Ingénierie des fluides Systèmes énergétiques (LIFSE)
  • Voir le document
  • Accueil de SAM
  • Laboratoire Ingénierie des fluides Systèmes énergétiques (LIFSE)
  • Voir le document
JavaScript is disabled for your browser. Some features of this site may not work without it.

Development of Attached Cavitation at Very Low Reynolds Numbers from Partial to Super-Cavitation

Article dans une revue avec comité de lecture
Auteur
ccRAVELET, Florent
1003528 Laboratoire d'Ingénierie des Fluides et des Systèmes Énergétiques [LIFSE]
DANLOS, Amélie
ccBAKIR, Farid
CROCI, Kilian
ccKHELLADI, Sofiane
ccSARRAF, Christophe

URI
http://hdl.handle.net/10985/21375
DOI
10.3390/app10207350
Date
2020
Journal
Applied Sciences

Résumé

The present study focuses on the inception, the growth, and the potential unsteady dynamics of attached vapor cavities into laminar separation bubbles. A viscous silicon oil has been used in a Venturi geometry to explore the flow for Reynolds numbers ranging from Re=800 to Re=2000. Special care has been taken to extract the maximum amount of dissolved air. At the lowest Reynolds numbers the cavities are steady and grow regularly with decreasing ambient pressure. A transition takes place between Re=1200 and Re=1400 for which different dynamical regimes are identified: a steady regime for tiny cavities, a periodical regime of attached cavity shrinking characterized by a very small Strouhal number for cavities of intermediate sizes, the bursting of aperiodical cavitational vortices which further lower the pressure, and finally steady super-cavitating sheets observed at the lowest of pressures. The growth of the cavity with the decrease of the cavitation number also becomes steeper. This scenario is then well established and similar for Reynolds numbers between Re=1400 and Re=2000.

Fichier(s) constituant cette publication

Nom:
LIFSE-AS-Ravelet-2020.pdf
Taille:
6.983Mo
Format:
PDF
Voir/Ouvrir
CC BY
Ce document est diffusé sous licence CC BY

Cette publication figure dans le(s) laboratoire(s) suivant(s)

  • Laboratoire Ingénierie des fluides Systèmes énergétiques (LIFSE)

Documents liés

Visualiser des documents liés par titre, auteur, créateur et sujet.

  • POD study of aerated cavitation in a venturi nozzle 
    Communication avec acte
    TOMOV, Petar; DANLOS, Amélie; ccRAVELET, Florent; ccSARRAF, Christophe; ccBAKIR, Farid; ccKHELLADI, Sofiane (IOP sciences conference series, 2015)
    The fact of injecting bubbles into a cavitating flow influences typical cavitating behavior. Cavitation and aerated cavitation experiments has been carried out on a symmetrical venturi nozzle with convergent/divergent ...
  • Experimental study of a novel centrifugal compressor with two successive and independent rotors 
    Article dans une revue avec comité de lecture
    NGUYEN, Van-Thang; ABED, Cheikh Brahim; DANLOS, Amelie; ccRAVELET, Florent; PARIDAENS, Richard; ccDELIGANT, Michael; ccKHELLADI, Sofiane; ccBAKIR, Farid (American Society of Mechanical Engineers, 2021)
    The present study deals with a low pressure-ratio centrifugal compressor consisting of two counter-rotating rotors called a Counter-Rotating Centrifugal Compressor (CRCC). The design method based on the loss model was ...
  • Numerical Analysis of a Novel Twin-Impeller Centrifugal Compressor 
    Article dans une revue avec comité de lecture
    NGUYEN, Van Thang; DANLOS, Amélie; ccRAVELET, Florent; ccDELIGANT, Michael; SOLIS, Moises; ccKHELLADI, Sofiane; ccBAKIR, Farid (MDPI AG, 2021)
    Centrifugal compressors are widely used in many industrial fields such as automotive, aviation, aerospace. However, these turbomachines suffer instability phenomenon when the flow rate is too high or too low, called rotating ...
  • CFD Analysis to explain the Operating range extension observed during Operation in Co-rotating Mode of a Twin-impeller Centrifugal Compressor 
    Article dans une revue avec comité de lecture
    NGUYEN, Van-Thang; DANLOS, Amelie; ccRAVELET, Florent; ccDELIGANT, Michael; SOLIS, Moises; ccKHELLADI, Sofiane; ccBAKIR, Farid (EDP Sciences, 2021)
    Centrifugal compressors are widely used in many industrial applications because of their advantages. However, these turbomachines suffer at a low-flow rate from instabilities, such as rotating stall and surge. That leads ...
  • Experimental study of the instationary flow between two ducted Counter-rotating rotors 
    Article dans une revue avec comité de lecture
    NOURI, Hussain; DANLOS, Amélie; ccRAVELET, Florent; ccSARRAF, Christophe; ccBAKIR, Farid (American Society of Mechanical Engineers, 2013)
    The purpose of this work is to study experimentally the aerodynamic characteristics of a subsonic counter-rotating axial-flow fans system operating in a ducted configuration. The fans of diameter D = 375 mm were designed ...

Parcourir

Tout SAMLaboratoiresAuteursDates de publicationCampus/InstitutsCe LaboratoireAuteursDates de publicationCampus/Instituts

Lettre Diffuser la Science

Dernière lettreVoir plus

Statistiques de consultation

Publications les plus consultéesStatistiques par paysAuteurs les plus consultés

ÉCOLE NATIONALE SUPERIEURE D'ARTS ET METIERS

  • Contact
  • Mentions légales

ÉCOLE NATIONALE SUPERIEURE D'ARTS ET METIERS

  • Contact
  • Mentions légales