Development of a quick-stop device for micro-cutting
Article dans une revue avec comité de lecture
Auteur
PIQUARD, RomainFONTAINE, MichaëlTHIBAUD, SébastienGILBIN, AlexandreLE COZ, Gaël 
ALAIN, D'acuntoRésumé
Micro-cutting is characterised by undeformed chip thicknesses in the micron range. This range leaves little choice of in situ observation techniques. One solution is therefore to observe these zones a posteriori after the cutting has been abruptly interrupted. This technique has proven to be very useful for conventional machining. This paper deals with the development of a quick-stop device dedicated to micro-cutting. The aim of this device is to observe cutting mechanisms and chip formation at this scale in order to enhance micro-cutting models.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Study of the Influence of Cutting Edge on Micro Cutting of Hardened Steel Using FE and SPH Modeling Article dans une revue avec comité de lecture; ; ; ; ; ; ; ;ALAIN, D'acunto (MDPI, 2022-07)
Micromachining allows the production of micro-components with complex geometries in various materials. However, it presents several scientific issues due to scale reduction compared to conventional machining. These issues ...
-
Communication avec acte; ; ;ALAIN, D'acunto; ; (Czech Machine Tool Society, 2014)
In order to model micro-milling cutting forces, a way is to apply a local model on discretized elements of the cutting edge and then summing on the whole edge to obtain the global cutting forces. This local model is usually ...
-
Communication avec acte; ;ALAIN, D'acunto; ; ; (Institut Français de Mécanique Avancée, 2014)
Cet article présente des essais de micro-coupe orthogonale et oblique à partir de tournage sur un acier 40NiCrMo16. Les résultats obtenus démontrent l’influence du rayon d’acuité d’arête sur les efforts mesurés notamment ...
-
Article dans une revue avec comité de lecture; ; ; ;ALAIN, D'acunto (Elsevier BV, 2022)
The success of biomedical implantation is linked to osseointegration, depending on the mechanical loading of the bone interface. The large difference in stiffness between the host bone (30 GPa) and the usual implant ...
-
Article dans une revue avec comité de lecture;ALAIN, D'acunto; ; (Elsevier, 2014)
This paper focuses on burr formation in micro-end milling of two Nickel-Titanium shape memory alloys (SMA), an austenitic and a martensitic NiTi. Phase transformation during machining was also examined. The experimental ...