Thermo-mechanical behaviour of TRIP 1000 steel sheets subjected to low velocity perforation by conical projectiles at different temperatures
TypeArticles dans des revues avec comité de lecture
This paper presents and analyzes the behaviour of TRIP 1000 steel sheets subjected to low velocity perforation by conical projectiles. The relevance of this material resides in the potential transformation of retained austenite to martensite during impact loading. This process leads to an increase in strength and ductility of the material. However, this transformation takes place only under certain loading conditions strongly dependent on the initial temperature and deformation rate. In order to study the material behaviour under impact loading, perforation tests have been performed using a drop weight tower. Experiments were carried out at two different initial temperatures T0 213 K and T0 288 K, and within the range of impact velocities 2.5 m/s 6 V0 6 4.5 m/s. The experimental setup enabled the measuring of impact velocity, residual velocity, load time history and failure mode. In addition, dry and lubricated contacts between the striker and the plate have been investigated. Finally, by using X ray diffraction it has been shown that no martensitic transformation takes place during the perforation process. The causes involving the none appearance of martensite are examined.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Visualiser des documents liés par titre, auteur, créateur et sujet.
Numerical simulation of the effect of adiabatic temperature increase in martensitic transformation of austenitic steels ZAERA, Ramon; CASADO, Alvaro; RODRIGUEZ-MARTINEZ, José Antonio; RUSINEK, Alexis; PESCI, Raphaël; FERNANDEZ-SAEZ, José (2011)This work presents a constitutive model for metastable austenitic steels exhibiting Strain Induced Martensitic Transformation (SIMT). Based on the description of the kinetics of phase transformation proposed by Olson and ...
Experimental and numerical analysis on the martensitic transformation in AISI 304 steel sheets subjected to perforation by conical and hemispherical projectiles RODRIGUEZ MARTINEZ, José Antonio; RUSINEK, Alexis; PESCI, Raphaël; ZAERA, Ramon (Elsevier, 2013)In this work, an experimental and numerical analysis of the martensitic transformation in AISI 304 steel sheets subjected to perforation by conical and hemispherical projectiles is conducted. Experiments are performed using ...
Numerical Simulation of the effect adiabatic temperature increase in martensitic transformation of austenitic steels ZAERA, Ramon; CASADO, Alvaro; RODRIGUEZ-MARTINEZ, José A.; RUSINEK, Alexis; PESCI, Raphaël; FERNANDEZ-SAEZ, José (2011)The predictions of the constitutive model agree with experimental results in terms of macroscopy stress-strain curves and volume fraction of martensite formed during loading
A constitutive model for analyzing martensite formation in austenitic steels deforming at high strain rates ZAERA, Ramon; RODRIGUEZ-MARTINEZ, J. A.; CASADO, Ana Maria; FERNANDEZ-SAEZ, José; RUSINEK, Alexis; PESCI, Raphaël (Elsevier, 2012)This study presents a constitutive model for steels exhibiting SIMT, based on previous seminal works, and the corresponding methodology to estimate their parameters. The model includes temperature effects in the phase ...
Mechanical charecterization and analytical modeling of the thermo-viscoplastic behaviour AISI 304 steel under wide ranges of strain rates at room temperature RODRIGUEZ-MARTINEZ, José A.; RUSINEK, Alexis; PESCI, Raphaël; ARIAS, Angel (2010)In this investigation, the thermo-viscoplastic behaviour of the steel AISI 304 has been examined. The experimental characterization of the material has been conducted in tension under wide ranges of strain rates.An analytical ...