Laboratoire Mechanics, Surfaces and Materials Processing (MSMP): Recent submissions

Now showing items 148-154 of 421

    • The effect of ageing process on three-point bending strength and permeability of 3D printed sand molds 
      Article dans une revue avec comité de lecture
      MITRA, Saptarshee; ccEL MANSORI, Mohamed; ccRODRIGUEZ DE CASTRO, Antonio (Springer Verlag, 2018)
      The objective of this paper was to investigate the effects of curing parameters (i.e., temperature and time), on the permeability and mechanical strength of the printed molds. Several sets of samples were hence produced ...
    • Wear study of structured coated belts in advanced abrasive belt finishing 
      Article dans une revue avec comité de lecture
      SERPIN, Kévin; MEZGHANI, Sabeur; ccEL MANSORI, Mohamed (Elsevier, 2015)
      Advanced belt finishing process is remarkably simple and inexpensive. The principle of operation is simple: pressure-locked shoes platens circumferentially press an abrasive coated belt on a rotating workpiece. This abrasive ...
    • Experimental and numerical study of tooth finishing processes contribution to gear noise 
      Article dans une revue avec comité de lecture
      JOLIVET, Simon; MEZGHANI, Sabeur; ccISSELIN, Jérôme; ccEL MANSORI, Mohamed (Elsevier, 2016)
      The contribution o fgear tooth flank surface micro-finish on gear noise has not yet been taken into consideration. This paper is devoted to study the simultaneous effect of tooth roughness and lubricant viscosity on ...
    • Multiscale assessment of structured coated abrasive grits in belt finishing process 
      Article dans une revue avec comité de lecture
      SERPIN, Kévin; MEZGHANI, Sabeur; ccEL MANSORI, Mohamed (Elsevier, 2015)
      This paper outlines the link between grit morphology and surface roughness of belt-finished workpieces.It features a comparative analysis of a new generation of abrasive belts with diverse abrasive structures,and a multi-scale ...
    • Effect of Si, Cu and processing parameters on Al-Si-Cu HPDC castings 
      Article dans une revue avec comité de lecture
      OUTMANI, Imane; FOUILLAND-PAILLE, Laurence; ccISSELIN, Jérôme; ccEL MANSORI, Mohamed (Elsevier, 2017)
      Chemical composition of secondary Al-Si-Cu alloys and working variables of high-pressure die casting process (HPDC) may change for the same casting parts from one country to another in the world. They can even sometimes ...
    • Geometrical effects on filling dynamics in low pressure casting of light alloys 
      Article dans une revue avec comité de lecture
      ccBEDEL, Marie; SANITAS, Antonin; ccEL MANSORI, Mohamed (Elsevier, 2019)
      In aluminum low-pressure sand casting process, filling oscillations are observed when the metal front reaches a section change in a part. The effect of geometry on the filling oscillations is primary considered experimentally, ...
    • Recent advances in drilling hybrid FRP/Ti composite: A state-of-the-art review 
      Article dans une revue avec comité de lecture
      XU, Jinyang; ccEL MANSORI, Mohamed; ccMKADDEM, Ali (Elsevier, 2016)
      Hybrid composite stack, especially FRP/Ti assembly, is considered as an innovative structural configuration for manufacturing the key load-bearing components favoring energy saving in the aerospace industry. Several ...