Coherency and Grain Size Effects on Solidification Crack Growth in Aluminum Welds
TypeArticles dans des revues avec comité de lecture
A mass-balance model has been evaluated that estimates the critical conditions for sustaining continuous crack growth in the weld mushy zone. With the aid of a strain partition model, the critical local strain rate (across the weld) has been related to the critical grain boundary deformation rate needed for crack growth. In the present work, these two models are applied to aluminum welds to investigate the theoretical effects of several metallurgical factors on solidification cracking susceptibility. Calculations quantify the improved cracking resistance associated with a smaller coherent temperature range, grain refinement, high solid fraction at coherency, and rapid development of strength.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Visualiser des documents liés par titre, auteur, créateur et sujet.
KURJI, Rahim; CONIGLIO, Nicolas (Springer, 2015)Industry and research have long desired the establishment of standards for weldability testing in regards to hydrogen assisted cold cracking formation. This would have the obvious advantage of allowing data to be reliably ...
CONIGLIO, Nicolas; SIVARUPAN, T.; EL MANSORI, Mohamed (SPRINGER, 2018)The development of sand mold three-dimensional printing technologies enables the manufacturing of molds without the use of a physical model. However, the effects of the three-dimensional printing process parameters on the ...
STOLZ, C.; CONIGLIO, Nicolas; MATHIEU, A.; AUBRETON, O. (SPIE, 2015)The search for an efficient on-line monitoring system focused on the real-time analysis of arc welding quality is an active area of research. The topography and the superficial temperature field of the weld pool can provide ...
CONIGLIO, Nicolas; MATHIEU, A.; AUBRETON, O.; STOLZ, C. (Taylor and Francis, 2016)This paper presents a passive polarimetry method using a division of aperture optical device in order to measure the temperature distribution at the weld pool surface. Thermal emission from a hot liquid metal was investigated ...
SANITAS, A.; CONIGLIO, Nicolas; BEDEL, M.; EL MANSORI, Mohamed (SPRINGER, 2017)The sand mold 3D printing technologies enable the manufacturing of molds with great dimensional accuracy. However, the roughness of as-cast components is higher when cast in a 3D printed mold rather than in a traditional ...