Control of a multi-degree of freedom worktool for vibrations assisted forging
Communication avec acte
Auteur
NGUYEN, Thanh HungAMBERG, MichelLEMAIRE-SEMAIL, BettyABBA, Gabriel 
GIRAUD-AUDINE, ChristopheRésumé
This paper addresses the control of a tool developed to superimpose vibrations along several directions on a piece during forging. Piezoelectric actuators are used to provide the required forces and speeds. Due to the minute displacements of the actuators, flexible hinges are used in a special arrangement in order realize the specified movements and to ensure controllability. The experimental results confirm the approach.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Communication avec acte; ; ; ;GIRAUD-AUDINE, Christophe (IEEE, 2014)
This paper presents the design of a mechatronic system integrating iezoelectric multi-actuators, which is used to generate low-frequency vibrations to assist the forging process. With the aim of controlling the complete ...
-
Article dans une revue avec comité de lecture; ; ;GIRAUD-AUDINE, Christophe (Institute of Electrical and Electronics Engineers, 2014)
This paper presents the modelling of a forging processes assisted by a piezoelectric actuator (PA), which is used to generate specific low frequency vibration waveforms. Experimental results show that such waveforms reduce ...
-
Communication avec acte; ; ;GIRAUD-AUDINE, Christophe (IEEE, 2012)
This paper deals with the modelling of a piezo- electric stack actuator used to generate specific low frequency vibration waveforms to assist forging processes. Experimental results show that such waveforms reduce the ...
-
Communication sans acte; ; ; ;GIRAUD-AUDINE, Christophe (2013)
Use of vibration in the forming process has already shown numerous advantages in the improvement of mechanical and surface properties of workpiece such as good surface or less friction between die and workpiece. The aim ...
-
Article dans une revue avec comité de lecture; ; ; ;GIRAUD-AUDINE, Christophe (EDP Sciences, 2014)
Application of vibration in metal forming process has already shown numerous advantages in the past. It improves not only mechanical and surface properties of workpiece but the integration of vibration in metal forming ...