Numerical andexperimentalanalysisofresidualstressandplasticstrain distributionsinmachinedstainlesssteel
Article dans une revue avec comité de lecture
In this study, a numerical approach has been developed to predict the near surface residual stresses and plastic strain resulting from turning in orthogonal cutting configuration. This approach is based on the Arbitrary Lagrangian–Eulerian (ALE) formulation using the commercial finite element code Abaqus–Explicit. The coefficients of the used material behavior law and friction model required for the simulation are identified experimentally in this study. The simulated results are validated by experiments carried out on AISI 316L stainless steel. Using this method, the effect of the depth of cut (Doc) and the cutting speed (Vc) on the surface properties has been established. The simulated residual stress gradient resulting from machining has been experimentally validated by X-ray diffraction measurements. The simulated plastic strain gradient has been validated by an experimental microhardness–strain relationship established in this study.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Visualiser des documents liés par titre, auteur, créateur et sujet.
Potential fatigue strength improvement of AA 5083-H111 notched parts by wire brush hammering: Experimental analysis and numerical simulation Article dans une revue avec comité de lectureSIDHOM, Naziha; BEN MOUSSA, Naoufel; JANEB, Sameh; BRAHAM, Chedly; SIDHOM, Habib (Elsevier, 2014)The effects of milling as machining process and a post-machining treatment by wire-brush hammering, on the near surface layer characteristics of AA 5083-H111 were investigated. Surface texture, work-hardening and residual ...
Assessment of low cycle fatigue improvement of machined AISI 316 stainless steel by brush hammering Article dans une revue avec comité de lectureSIDHOM, Naziha; MAKHLOUF, Kamel; KHLIFI, Ammar; BRAHAM, Chedly; SIDHOM, Habib (Wiley-Blackwell, 2014)The effects of wire brush hammering on low cycle fatigue behaviour of AISI 316 austenitic stainless steel has been investigated on turned samples through an experimental study combining strain controlled fatigue tests, ...
Article dans une revue avec comité de lectureMAKHLOUF, Kamel; SIDHOM, Naziha; KHLIFI, Ammar; SIDHOM, Habib; BRAHAM, Chedly (Elsevier, 2013)The effects of hammering by wire brush as a method of improving low cycle fatigue life of highly ductile austenitic stainless steel AISI 304 have been investigated through an experimental study combining imposed strain ...
Effect of machining processes on the residual stress distribution heterogeneities and their consequences on the stress corrosion cracking resistance of AISI 316L SS in chloride medium Article dans une revue avec comité de lectureRHOUMA, Amir Ben; SIDHOM, Naziha; MAKHLOUF, Kamel; SIDHOM, Habib; BRAHAM, Chedly; GONZÁLEZ, Gonzalo (Springer Verlag, 2019)The effects of machining such as grinding and turning on the microstructural and mechanical changes of the machined surfaces of AISI 316L stainless steel (SS) have been studied. Surface aspects and surface defects have ...
Effect of interlamellar spacing on the elastoplastic behavior of C70 pearlitic steel: Experimental results and self-consistent modeling Article dans une revue avec comité de lectureYAHYAOUI, Houda; SIDHOM, H; BRAHAM, Chedly; BACZMANSKI, Andrzej (Elsevier, 2014)The effect of pearlite microstructure characteristics on strength and deformation of C70 pearlitic steel was investigated. Tensile tests under X-ray diffraction coupled with self-consistent model have been used to identify ...