SAM: Soumissions récentes
Voici les éléments 1002-1008 de 6441
-
Article dans une revue avec comité de lecture; ; ;
POT, Guillaume; VIGUIER, Joffrey (2022)
Efficient utilization of structural timber requires accurate methods for machine strength grading. One of the most accurate methods presented this far is based on data of local fiber orientation on board surfaces, obtained ... -
Article dans une revue avec comité de lecture; ; ; ; ;DUMONT, Myriam (AIP Publishing, 2022-11)
This paper discusses the use of electron backscattered diffraction to characterize restructuring in a set of UO2 samples, irradiated in a pressurized water reactor at a burn-up between 35 and 73 GWd/tU, including standard ...
-
Article dans une revue avec comité de lecture; ;DUMONT, Myriam; ; CLENET, Stephane (Elsevier BV, 2022-12)
This paper deals with the temperature-dependent modelling of iron losses in the context of magnetic ageing of electricals steel used in high power electrical machines. First, two electrical steel sheet grades were heat ...
-
Article dans une revue avec comité de lecture; ; ; ; ;DUMONT, Myriam (AIP Publishing, 2022-11)
Focussed ion beam - scanning electron microscope (FIB-SEM) 3D examination was conducted on three standard UO2 and one Cr doped UO2 high burn-up pressurized water reactor (PWR) fuel samples. This work complemented other ...
-
Article dans une revue avec comité de lecture;PESSARD, Etienne; MOREL, Franck; (Elsevier BV, 2017-01-14)
Hot-forging is a process commonly used in the manufacturing of automobile parts such as connecting rods. Most hot-forged components are shot-blasted after forging in order to clean off the forging scale. The shotblasting ...
-
Communication avec acte;MOREL, Franck; PESSARD, Etienne; BELLETT, Daniel; ; (Elsevier BV, 2019-12-24)
Jet engines gears are generally made of steel and are case-strengthened via thermochemical treatments such as carburizing or nitriding causing microstructural modifications, superficial hardening and compressive residual ...
-
Communication avec acteABROUG, Foued; PESSARD, Etienne; GERMAIN, Guénaël; MOREL, Franck (EDP Sciences, 2018-05-25)
One objective of this project is to propose a fatigue design approach that is able to account for a large range of machining surface defects and different component sizes and geometries. Due to the huge size difference ...
