SAM: Soumissions récentes
Voici les éléments 1036-1042 de 6449
-
Article dans une revue avec comité de lecture;
AHMADI-SENICHAULT, Azita; ; (Springer Science and Business Media LLC, 2022-04-13)
The direct proportionality between the flow rate and the pressure gradient of creeping flows was experimentally discovered by H. Darcy in the 19th century and theoretically justified a couple of decades ago using upscaling ... -
Article dans une revue avec comité de lecture; ; ; ;CHEVALIER, Stéphane (MDPI AG, 2022-03-23)
Proton Exchange Membrane Fuel Cells (PEMFCs) are clean energy conversion devices that are widely used in various energy applications. In most applications, the main challenge is accurately estimating the state of health ...
-
Study of the Influence of Cutting Edge on Micro Cutting of Hardened Steel Using FE and SPH Modeling Article dans une revue avec comité de lecture(MDPI, 2022-07)Micromachining allows the production of micro-components with complex geometries in various materials. However, it presents several scientific issues due to scale reduction compared to conventional machining. These issues ...
-
Communication avec acte; ; ;DAZIN, Antoine; JOSEPH, Pierric (EUCASS association, 2022-06-27)
This paper presents the design and the characterization of a pulsed air injection system on a single stage axial compressor. The goal of this system is to delay the rotating stall onset and to extend the compressor operating ...
-
Article dans une revue avec comité de lecture; ; ; ; ;PESCI, Raphaël (MDPI, 2022-09)
Al-7Si-0.5Mg aluminum alloy semi-solid slurry with good spherical grains was prepared by gas induced semi-solid process (GISS) and the effects of both holding time and medium alloy addition on the microstructure of the ...
-
Article dans une revue avec comité de lecture; ; ;PIOTROWSKI, Boris; ; BERVEILLER, Sophie; KUBLER, Regis (Springer Science and Business Media LLC, 2022-11)
The present work deals with the study of the damping capacity of b-metastable Ti–(24–26) Nb alloys. In this work, several methods have been used to characterize this damping. The impact tests were carried out using ...
-
Conférence invitée;BAUDOUIN, Cyrille; DURAND, Camille (Association Française de Mécanique, 2022)
In the aeronautical sector, because parts are mainly of large dimensions and in high performance materials, products are forged in small batches. Forming these complex parts requires energy-controlled production means, ...
