SAM: Soumissions récentes
Voici les éléments 1132-1138 de 6547
-
Chapitre d'ouvrage scientifique;
KLEMENT, Nathalie (Wiley, 2022-06)
Production systems adapt to market changes and integrate technical and social progress. These systems are therefore now qualified as reconfigurable manufacturing systems. In order to ensure this reconfigurability, a robust ... -
Chapitre d'ouvrage scientifique; ;GIBARU, Olivier; ; KLEMENT, Nathalie (Springer International Publishing, 2022-09)
The durability of an automobile factory depends on its flexibility and its evolution capacity to meet market expectations. These expectations tend increasingly to the vehicles’ customization. Therefore, automobile factories ...
-
Article dans une revue avec comité de lecture;AHMADI-SENICHAULT, Azita; ; (Springer Science and Business Media LLC, 2022-04-13)
The direct proportionality between the flow rate and the pressure gradient of creeping flows was experimentally discovered by H. Darcy in the 19th century and theoretically justified a couple of decades ago using upscaling ...
-
Article dans une revue avec comité de lecture; ; ; ;CHEVALIER, Stéphane (MDPI AG, 2022-03-23)
Proton Exchange Membrane Fuel Cells (PEMFCs) are clean energy conversion devices that are widely used in various energy applications. In most applications, the main challenge is accurately estimating the state of health ...
-
Study of the Influence of Cutting Edge on Micro Cutting of Hardened Steel Using FE and SPH Modeling Article dans une revue avec comité de lecture; ; ; ; ; ; ; ;ALAIN, D'acunto (MDPI, 2022-07)
Micromachining allows the production of micro-components with complex geometries in various materials. However, it presents several scientific issues due to scale reduction compared to conventional machining. These issues ...
-
Communication avec acte; ; ;DAZIN, Antoine; JOSEPH, Pierric (EUCASS association, 2022-06-27)
This paper presents the design and the characterization of a pulsed air injection system on a single stage axial compressor. The goal of this system is to delay the rotating stall onset and to extend the compressor operating ...
-
Article dans une revue avec comité de lecture; ; ; ; ;PESCI, Raphaël (MDPI, 2022-09)
Al-7Si-0.5Mg aluminum alloy semi-solid slurry with good spherical grains was prepared by gas induced semi-solid process (GISS) and the effects of both holding time and medium alloy addition on the microstructure of the ...
