SAM: Soumissions récentes
Voici les éléments 2294-2300 de 6547
-
Article dans une revue avec comité de lecture(Elsevier, 2019)The oxidation of 316 L stainless steel in hydrogenated supercritical water at 600 °C is strongly dependent on the effects of work hardening induced by surface finishes. The oxide scale formed under these conditions is ...
-
Article dans une revue avec comité de lecture;
DELIGANT, Michael; KHELLADI, Sofiane (ELSEVIER, 2015)
This paper presents a two phases flow model combined with a high order finite volume solver on unstructured mesh. The solver is highly conservative and preserves the sharpness of the interface without any reconstruction. ... -
Article dans une revue avec comité de lecture; ; ; ; ;BRAHAM, Chedly (Springer Verlag, 2019)
The effects of machining such as grinding and turning on the microstructural and mechanical changes of the machined surfaces of AISI 316L stainless steel (SS) have been studied. Surface aspects and surface defects have ...
-
Article dans une revue avec comité de lecture(Elsevier, 2010)Along with carbon nanotubes (CNT) morphology, impurity, and functionalization, polymer curing cycle is another important factor in determining the mechanical properties of the CNT/polymer composite samples. This work ...
-
Article dans une revue avec comité de lecture; ; ; ; ; ;COLIN, Xavier (Elsevier, 2019)
The water sorption properties (i.e. diffusivity and solubility) of three unfilled vulcanized EPDMs were investigated in wet atmosphere (typically between 0 and 95% RH) and in pure distilled water (denoted as 100% RH) at ...
-
Article dans une revue avec comité de lecture(Elsevier, 2010)χ-, κ- and α-alumina phases formed by dehydration of micro-grained gibbsite between 773 and 1573 K are studied using infrared spectroscopy (IR). The structural transitions evidenced by X-ray diffraction (XRD) were interpreted ...
-
Article dans une revue avec comité de lecture(MDPI, 2019)Centrifugal pumps are widely used and are known to be sensitive to inlet air-water two-phase flow conditions. The pump performance degradation mainly depends on the changes in the two-phase flow behavior inside the pump. ...
