SAM: Soumissions récentes
Voici les éléments 2544-2550 de 6547
-
Article dans une revue avec comité de lecture(Springer Verlag, 2018)Purpose The global appearance of scoliosis in the horizontal plane is not really known. Therefore, the aims of this study were to analyze scoliosis in the horizontal plane using vertebral vectors in two patients classified ...
-
Article dans une revue avec comité de lecture; ; ; ;
MONTEIRO, Eric (Wiley-Blackwell, 2020)
The mechanical behavior of polyethylene terephthalate (PET) under the severe loading conditions of the injection stretch blow molding process is strongly dependent on strain rate, strain, and temperature. In this process, ... -
Demagnetization analysis of an open-end windings 5-phase PMSM under transistor short-circuit fault Communication avec acte;NGUYEN, Ngac Ky; SEMAIL, Eric (IEEE, 2019)
For an open-end windings integrated Permanent Magnet Synchronous Machine, the demagnetization of the permanent magnets is analyzed when a transistor is short-circuited and no specific control strategy is adopted. Depending ...
-
Communication avec acte;NGUYEN, Ngac Ky; SEMAIL, Eric (2020)
This paper proposes a new sensorless control strategy based on a Sliding Mode Observer (SMO) for a non-sinusoidal seven phase PMSMs. This strategy, based on all harmonics contained in the back-EMF, is compared to the ...
-
Article dans une revue avec comité de lecture; ;JACQUET, Philippe; ; ; NOUVEAU, Corinne (Wiley-VCH Verlag, 2019)
In this article the results concerned influence of processing conditions of the wire electrical discharge machining and vibro‐abrasive machining on the surface layer and morphology of samples made of hard machinable materials ...
-
Chapitre d'ouvrage scientifique; ; ;ROBINET, Jean-Christophe (Springer, 2017)
Turbulent flows of industrial interest are often dominated by large turbulent structures. A typical example is provided by launcher base flows, combining one or more extended and interacting separated regions with strong ...
-
Article dans une revue avec comité de lecture;AYED, Yessine; ; GERMAIN, Guénaël (Taylor & Francis, 2020)
The numerical analysis, based on the finite element modeling (FEM), presents nowadays an efficient computational tool. It allows a better understanding of several thermo-mechanical phenomena involved during the machining ...
