SAM: Soumissions récentes
Voici les éléments 257-263 de 6448
-
Article dans une revue avec comité de lecture
EBRAHIMIAN, Fariba; ; DI LORENZO, Daniele; CHINESTA SORIA, Francisco (Springer Science and Business Media LLC, 2024-06-01)
AbstractThis study aims to provide precise predictions for the compression of reinforced polymers during the sheet Molding Compound (SMC) process, ensuring the attainment of a predefined structure while preventing material ... -
Communication avec acte;BEN SAADA, Mariem; LAVISSE, BRUNO; RITOU, Mathieu; GERMAIN, Guenael (Materials Research Forum LLC, 2024-05-15)
The estimation of post-machining distortion of monolithic aeronautical parts induced by the redistribution of the bulk residual stresses (RS) during machining is one of the major challenges of aeronautical parts manufacturing. ...
-
Communication avec acte;YESSINE, AYED; LAVISSE, BRUNO; GERMAIN, Guenael (Materials Research Forum LLC, 2024-05-15)
During machining, the friction between the tool and the workpiece (cutting face and flank face) is a significant tribological phenomenon because it strongly influences the cutting operation. Indeed, higher friction leads ...
-
Article dans une revue avec comité de lecture;RITOU, Mathieu; LAVISSE, BRUNO; GERMAIN, Guenael; (Elsevier BV, 2022)
Aluminum alloys are widely used for structural parts in the aerospace industry. Those parts are usually machined from rolled plates or forged blanks, and heat treatments are carried out to reach the necessary mechanical ...
-
Article dans une revue avec comité de lectureLAVISSE, BRUNO; ; BONDARENKO, Dmitry; ; GERMAIN, Guenael (Informa UK Limited, 2023-09-14)
The use of aluminum-lithium alloys in aeronautics is an efficient solution for lightweight structures, but its machinability can cause increased tool wear. The cutting temperature is one of the most important parameters ...
-
Article dans une revue avec comité de lectureSTIEF, Paul; DANTAN, Jean-Yves; ETIENNE, Alain; SIADAT, Ali (Springer, 2024-11)
The design and use of assembly systems for more than one dedicated product becomes more important to manufacturing industries as product variety increases and lot sizes decrease. Since their introduction in the late 90’s, ...
-
Article dans une revue avec comité de lectureURIBE, David; DURAND, Camille; BAUDOUIN, Cyrille; BIGOT, Regis (Springer Science and Business Media LLC, 2024-10)
Numerical simulations are crucial for predicting outcomes in forging processes but often neglect dynamic interactions within forming tools and presses. This study proposes an approach for achieving accurate real-time ...
