SAM: Soumissions récentes
Voici les éléments 2651-2657 de 6547
-
Communication avec acte;
THOMAS, Olivier; ; KESTELYN, Xavier (IEEE, 2019)
Today's power systems are strongly nonlinear and are becoming more complex with the large penetration of power-electronics interfaced generators. Conventional Linear Modal Analysis does not adequately study such a system ... -
Article dans une revue avec comité de lecture; ; ;RAVELET, Florent; BAKIR, Farid; KHELLADI, Sofiane (SAGE Publications, 2017)
In an axial fan, a leakage flow driven by a pressure gradient between the pressure side and the suction side occurs in the gap between the shroud and the casing. This leakage flow is in the opposite direction to the main ...
-
Article dans une revue avec comité de lecture(Elsevier, 2019)Due to the population growth and the increased reliance on cooling and heating systems, buildings have become the largest energy consumer worldwide. The use of phase change material (PCM) has shown great potential to reduce ...
-
Article dans une revue avec comité de lecture; ; ; ;DARU, Virginie (Cambridge University Press (CUP), 2019)
Acoustic streaming generated by a plane standing wave between two infinite plates or inside a cylindrical tube is considered, under the isentropic flow assumption. A two-dimensional analysis is performed in the linear case ...
-
Article dans une revue avec comité de lecture; ; ; ; ;NOUVEAU, Corinne (Elsevier, 2019)
Vanadium carbide coatings were deposited by R.F. reactive magnetron sputtering at different nitrogen partial pressures. The structures and the mechanical and tribological behaviour of these coatings were studied. By using ...
-
Article dans une revue avec comité de lecture;NOUVEAU, Corinne; NASSER EDDINE, BELIARDOUH; ; ; (Elsevier, 2020)
Multilayered and nanostructured coatings of Ti based alloys (oxides and nitrides) are elaborated and tested for increasing protective properties such as corrosion and wear resistances. A pin-on-disc tribometer was used to ...
-
Article dans une revue avec comité de lecture; ; ; ; ;ROUCH, Philippe (BioMed Central, 2015)
Introduction To evaluate the accuracy of CAD/CAM generated splints in orthognathic surgery by comparing planned versus actual post-operative 3D images. Methods Specific planning software (SimPlant® OMS Standalone 14.0) was ...
