SAM: Soumissions récentes

Voici les éléments 2723-2729 de 6547

    • Effect of shot peening on microstructure of steels exhibiting a TRIP effect – Experimental and modeling approaches 
      Communication avec acte
      GUIHEUX, Romain; BOUSCAUD, Denis; PATOOR, Etienne; PUYDT, Quentin; ccBERVEILLER, Sophie; ccKUBLER, Regis (12th International Conference on the Mechanical Behavior of Materials, 2015)
      Shot peening process is commonly used in mechanical industries to increase life duration of mechanical and structural parts, as automotive gears for instance. It is based on the development of residual compressive stresses ...
    • To curl or not to curl : wind tunnel investigation of spinnaker performance 
      Communication avec acte
      AUBIN, Nicolas; AUGIER, Benoit; DEPARDAY, Julien; SACHER, Matthieu (Ecole Navale, 2017)
      This work presents a wind tunnel experimental study of the effect of curling on the spinnaker aerodynamic performance. Four spinnakers combining two different panellings and sail materials are tested at different wind ...
    • Wind-tunnel pressure measurements on model-scale rigid downwind sails 
      Communication avec acte
      ccBOT, Patrick; VIOLA, Ignazio Maria; FLAY, Richard G.J.; BRETT, Jean-Sébastien (Ecole Navale, 2013)
      This paper describes an experiment that was carried out in the Twisted Flow Wind Tunnel at The University of Auckland to measure a detailed set of pressure distributions on a rigid 1/15th scale model of a modern asymmetric ...
    • Towards a declarative modeling approach built on top of a CAD modeler 
      Article dans une revue avec comité de lecture
      DANIEL, Marc; DÉCRITEAU, Dorian; ccPERNOT, Jean-Philippe (CAD Solutions LLC (imprimé) and Taylor & Francis Online (en ligne), 2016)
      Today’s CAD modelers are very efficient in processing 3D shapes of CAD models by means of B-Rep modeling operators such as pad, pocket, shaft, groove, hole, fillet and so on. At a lower description level, those modeling ...
    • Thermal Effects on Tribological Behavior in Machining Natural Fiber Composites 
      Communication avec acte
      TAKABI, Behrouz; TAI, Bruce; BUKKAPATNAM, Satish; ccEL MANSORI, Mohamed; ccCHEGDANI, Faissal (ELSEVIER, 2018)
      Machining natural fibers reinforced plastic (NFRP) composites is nowadays a real challenge for academia and industries. These eco-friendly materials are emerging in automotive and aeronautical industries thanks to many ...
    • Experimental study of coated tools effects in dry cutting of natural fiber reinforced plastics 
      Article dans une revue avec comité de lecture
      MEZGHANI, Sabeur; ccEL MANSORI, Mohamed; ccCHEGDANI, Faissal (Elsevier, 2015)
      This work aims to investigate the tribological effects of coated tools on the surface finish of natural fiber reinforced plastics (NFRPs) during profile milling process with particular emphasis on the natural fiber cutting ...
    • On the multiscale tribological signatures of the tool helix angle in profile milling of woven flax fiber composites 
      Article dans une revue avec comité de lecture
      MEZGHANI, Sabeur; ccEL MANSORI, Mohamed; ccCHEGDANI, Faissal (Elsevier, 2016)
      The present study is focused on tribological and multiscale analysis for the machined surfaces of bi-directional flax fibers reinforced polypropylene composites. This is to track the multiscale effect of the helix angle ...