SAM: Soumissions récentes
Voici les éléments 539-545 de 6441
-
Wave statistics and energy dissipation of shallow-water breaking waves in a tank with a level bottom Article dans une revue avec comité de lecture; ;
BAYEUL-LAINÉ, Annie-Claude; ; ; COUTIER-DELGOSHA, Olivier (Cambridge University Press (CUP), 2023-11)
The present study focuses on two-dimensional direct numerical simulations of shallow-water breaking waves, specifically those generated by a wave plate at constant water depths. The primary objective is to quantitatively ... -
Article dans une revue avec comité de lectureGHNATIOS, Chady; BARASINSKI, Anaïs; CUETO, Elias (Frontiers, 2023-01)
The problem of efficiently building digital twins in the framework of materials manufacturing processes and materials modeling is thus, nowadays, a topic of increasing interest. Recent advances in digital twin technologies ...
-
Article dans une revue avec comité de lecture;NAIT ABDELAZIZ, Moussa; FAYOLLE, Bruno; ; ; (2023)
Environmental aging induces a slow and irreversible alteration of the rubber material’s macromolecular network. This alteration is triggered by two mechanisms which act at the microscale: crosslinking and chain scission. ...
-
Article dans une revue avec comité de lectureSANCARLOS, Abel; ; CUETO, Elias; CHINESTA SORIA, Francisco (Springer Open, 2023-03)
Regressions created from experimental or simulated data enable the construction of metamodels, widely used in a variety of engineering applications. Many engineering problems involve multi-parametric physics whose corresponding ...
-
Article dans une revue avec comité de lecture; ;AHZI, Said; ; ; CHINESTA SORIA, Francisco; (Elsevier, 2023-04)
Recently published research indicated that, in additive manufacturing fields, single fiber reinforcements often increased some mechanical properties of composites, but at the same time decreased other mechanical behaviors, ...
-
Article dans une revue avec comité de lectureAHMADIFAR, Mohammad; SHIRINBAYAN, Mohammadali; BENFRIHA, Khaled (Springer, 2023-06)
In the recent years, additive manufacturing (AM) has been widely expanded for manufacturing the polymer and polymer-based composite parts. The main drawback of the material extrusion additive manufactured parts is the ...
-
Article dans une revue avec comité de lectureTCHARKHTCHI, Abbas; VILLALONGA, Stephane; ZIRAK, Nader; ; FARZANEH, Sedigheh; SHIRINBAYAN, Mohammadali (2023)
The design of 700-bar composite tanks considering the safety factor imposes resistance to a bursting pressure greater than 1645 bars remains difficult which leads to the addition of carbon fibers. On the other hand, the ...
