SAM: Recent submissions

Now showing items 2667-2673 of 6547

    • Dense-gas effects on compressible boundary-layer stability 
      Article dans une revue avec comité de lecture
      CINNELLA, Paola; GRASSO, Francesco; ccROBINET, Jean-Christophe; ccSCIACOVELLI, Luca; ccGLOERFELT, Xavier (Cambridge University Press (CUP), 2020)
      A study of dense-gas effects on the stability of compressible boundary-layer flows is conducted. From the laminar similarity solution, the temperature variations are small due to the high specific heat of dense gases, ...
    • Orthogonal cutting mechanisms of CFRP/Ti6Al4V stacks 
      Article dans une revue avec comité de lecture
      XU, Jinyang; CHEN, Ming; REN, Fei; ccEL MANSORI, Mohamed (Springer Verlag, 2019)
      The enhanced mechanical/physical properties and improved functionalities have made the carbon fiber–reinforced polymer/titanium alloy (CFRP/Ti6Al4V) stacks very attractive to the modern aerospace industry. However, the ...
    • An investigation of drilling high-strength CFRP composites using specialized drills 
      Article dans une revue avec comité de lecture
      XU, Jinyang; LI, Chao; CHEN, Ming; REN, Fei; ccEL MANSORI, Mohamed (Springer Verlag, 2019)
      Machining of high-strength carbon fiber reinforced polymers (CFRPs) has faced great challenges in quality control and tool wear management due to their inherent heterogeneity and high abrasiveness leading to serious workpiece ...
    • Numerical study on the chip removal and surface quality of CFRP/Ti6Al4V stacks 
      Article dans une revue avec comité de lecture
      ccEL MANSORI, Mohamed; XU, JYNIANG (NISCAIR, 2019)
      Machining of multilayer stacks constituted by carbon fibre reinforced polymer (CFRP) composites and titanium (Ti) alloys has been a hot topic receiving extensive attention in both academia and industry due to their superior ...
    • Off-line path programming for three-dimensional robotic friction stir welding based on Bézier curves 
      Article dans une revue avec comité de lecture
      KOLEGAIN, Komlan; LEONARD, François; ZIMMER-CHEVRET, Sandra; BEN ATTAR, Amarilys; ABBA, Gabriel (Emerald, 2018)
      Robotic friction stir welding (RFSW) is an innovative process which enables solid-state welding of aluminum parts using robots. A major drawback of this process is that the robot joints undergo elastic deformation during ...
    • Influence of the Shape on the Roughness-Induced Transition 
      Ouvrage scientifique
      CHERUBINI, Stefania; LERICHE, Emmanuel; ccROBINET, Jean-Christophe; ccLOISEAU, Jean-Christophe (Springer, 2015)
      lobal instability analysis of the three-dimensional flow past two rough- ness elements of different shape, namely a cylinder and a bump, is presented. In both cases, the eigenspectrum is made of modes characterised by a ...
    • Short isthmic versus long trans-isthmic C2 screw : anatomical and biomechanical evaluation 
      Article dans une revue avec comité de lecture
      LUCAS, François; MITTON, David; FRECHEDE, Bertrand; BARREY, Cédric (Springer-Verlag, 2016)
      INTRODUCTION: The Harms technique is now considered as the gold standard to stabilize C1-C2 cervical spine. It has been reported to decrease the risk of vertebral artery injury. However, the risk of vascular injury does ...