Microstructure and Texture of Al2SixSn (x = 0, 4, 8 mass%) Alloys Processed by Equal Channel Angular Pressing
Article dans une revue avec comité de lecture
The influence of Sn on the microstructure, microstrain and grain morphology in Al–2Si–xSn samples processed by ECAP is reported and discussed. The pseudo-binary Al–xSn alloys (where x = 0, 4, 8 mass%) were produced by conventional ingot casting. Samples were characterised by X-ray diffractometry (XRD), transmission electron microscopy (TEM), dynamical mechanical analysis (DMA) and microhardness. Results showed that the initial texture was modified after several ECAP passes and the formation of subgrains were observed. The presence of Sn enhanced the tribological properties of the alloy but, the ECAP capacity for grain refining was reduced. Besides, it was also confirmed that the damping capacity and microhardness behaviour were dependent of the Sn contents.
Showing items related by title, author, creator and subject.
Article dans une revue avec comité de lectureRUIZ, Carlos Reyes; FIGUEROA, Ignacio A.; BRAHAM, Chedly; CABRERA, José M.; ISMELI, Alfonso; GONZALEZ, Gonzalo (Nihon Kinzoku Gakkai, 2015)Equal channel angular pressing (ECAP) is a severe plastic deformation (SPD) technique that produces nanostructured materials. Based on a remarkable grain size reduction, this process has led to improve mechanical properties, ...
Microstructure and texture evolution of the Al-20sn alloy processed by equal-channel angular pressing using route C Article dans une revue avec comité de lectureHERNÁNDEZ, Cristopher L.; FIGUEROA, Ignacio A.; LÓPEZ, Ismeli Alfonso; BRAHAM, Chedly; CASTILLO, Patricia; GONZÁLEZ, Gonzalo (Nihon Kinzoku Gakkai, 2014)In this work, the microstructure and texture evolution of an Al-20Sn (mass%) alloy processed by Equal Channel Angular Pressing is presented. The evolution of dislocation cells into subgrains and the mechanical response of ...
Article dans une revue avec comité de lectureBRAHAM-BOUCHNAK, Tarek; GERMAIN, Guénaël; ROBERT, Patrick; LEBRUN, Jean-Lou; AUGER, Stéphane (Springer Verlag, 2010)High pressure water jet assisted turning (HPWJAT) consists of projecting a high pressure water jet, up to several hundred bar, into the tool-workpiece interface. The water jet is directed between the chip and the tool ...
Article dans une revue avec comité de lectureGERMAIN, Guénaël; LEBRUN, Jean-Lou; BRAHAM-BOUCHNAK, Tarek; BELLETT, Daniel; AUGER, Stéphane (SpringerLink, 2008)Laser assisted machining (LAM) can improve the machinability of materials by locally heating the material prior to its removal. The work presented here is a study of the laser assisted machining of Inconel 718 (NiCr19FeNb ...
Article dans une revue avec comité de lectureBRAHAM-BOUCHNAK, Tarek; GERMAIN, Guénaël; MOREL, Anne; LEBRUN, Jean-Lou (Springer Verlag, 2013)The Ti533-3 alloy is a new titanium alloy which is starting to see increased use in the aeronautical domain to improve the durability of components and to optimize the weight/resistance ratio. This alloy is characterized ...