Microstructure and texture evolution of the Al-20sn alloy processed by equal-channel angular pressing using route C
TypeArticles dans des revues avec comité de lecture
In this work, the microstructure and texture evolution of an Al-20Sn (mass%) alloy processed by Equal Channel Angular Pressing is presented. The evolution of dislocation cells into subgrains and the mechanical response of the deformed alloy have been emphasized. Samples were characterized by transmission electron microscopy, X-ray diffraction (for microstrain and texture measurements) and Vickers microhardness. It was found, that Al grains, suffered the highest degree of deformation during the ECAP process, however, the evidence showed that the deformation was largely heterogeneous, in terms of crystalline domain and feasibly in misorientation angles. The initial copper texture changes throughout the ECAP process forming an incipient shear texture component (111)[11-2]. The heterogeneity of the results obtained from the Vickers microhardness mapping could be associated to the microstructure resulted after the ECAP process. © 2014 The Japan Institute of Metals and Materials.
Showing items related by title, author, creator and subject.
RUIZ, Carlos Reyes; FIGUEROA, Ignacio A.; BRAHAM, Chedly; CABRERA, José M.; ISMELI, Alfonso; GONZALEZ, Gonzalo (Japan Institute of Metals and Materials, 2015)Equal channel angular pressing (ECAP) is a severe plastic deformation (SPD) technique that produces nanostructured materials. Based on a remarkable grain size reduction, this process has led to improve mechanical properties, ...
Microstructure and Texture of Al2SixSn (x = 0, 4, 8 mass%) Alloys Processed by Equal Channel Angular Pressing GONZALEZ, Gonzalo; BRAHAM, Chedly; LEBRUN, Jean-Lou; CHASTEL, Yvan; SEILER, Wilfrid; FIGUEROA, Ignacio A. (Japan Institute of Metals, 2012)The influence of Sn on the microstructure, microstrain and grain morphology in Al–2Si–xSn samples processed by ECAP is reported and discussed. The pseudo-binary Al–xSn alloys (where x = 0, 4, 8 mass%) were produced by ...
Production of al foams using the SDP method: Processing parameters and introduction of a new sintering device FIGUEROA, Ignacio A.; NOVELO-PERALTAA, O.; GONZÁLEZA, G.; LARA-RODRÍGUEZA, G. A.; LÓPEZ, Ismeli Alfonso (Technical Faculty in Bor, 2016)The processing of aluminum (Al) foams with maximum porosity of around 70 %, regular pore size and interconnected pores were successfully produced by means of the powder metallurgy method of Sintering Dissolution Process ...
Effect of electro discharge machining (EDM) on the AISI316L SS white layer microstructure and corrosion resistance SIDHOM, Habib; GHANEM, Farhat; AMADOU, Tidiane; GONZALEZ, Gonzalo; BRAHAM, Chedly (Springer, 2013)The localised corrosion resistance of austenitic stainless steels is strongly influenced by the quality of finished surface. EDM machining induces substantial changes by the high thermal gradients generated by electric ...
ROMERO-RESENDIZ, L.; REYES-RUIZ, Carlos; CABRERA, José María; BRAHAM, CHEDLY; GONZÁLEZ, Gonzalo (Elsevier Inc., 2019)The mechanical behavior and microstructural evolution of an AA2017 aluminum alloy processed by ECAP with an equivalent simple shear deformation of ∼6 at 200 °C were studied. Samples were characterized by means of scanning ...