Micro-EDM numerical simulation and experimental validation
Communication avec acte
Auteur
BIGOT, SamuelSURLERAUX, AnthonyELKASEER, Ahmed 
PERNOT, Jean-PhilippeRésumé
This paper introduces a new method for simulating the micro-EDM process in order to predict tool wear. The tool and workpiece are defined by NURBS surfaces whose shapes result from an iterative crater-by-crater deformation technique driven by physical parameters. The simulation method is validated through a comparison with experimental data. Different simulations are presented with an increase in computation accuracy in order to study its influence on the results and their deviation from expected values.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lecture; ; ;PERNOT, Jean-Philippe (Springer Verlag, 2016)
This paper introduces a new method for simulat- ing the micro-EDM process in order to predict both the tool’s wear and the workpiece’s roughness. The tool and workpiece are de ned by NURBS patches whose shapes result from ...
-
Article dans une revue avec comité de lecture; ; ;PERNOT, Jean-Philippe (Future Technology Press, 2015)
This paper describes a new efficient method for computer aided optimisations of micro EDM die sinking tools, which can be used for design optimisation and performance verification in the digital domain. This would facilitate ...
-
Article dans une revue avec comité de lecture; ; ; ;PERNOT, Jean-Philippe (Elsevier, 2016)
This paper presents a new approach for the recording of the total quantity of energy exchanged during the micro electrical discharge machining (EDM) process. In particular, this approach allows for the estimation of the ...
-
Communication avec acte; ; ; ; ;PERNOT, Jean-Philippe (2014)
This paper presents a new approach for the recording of the total quantity of energy exchanged during the micro Electro Discharge Machining (EDM) process. In particular, this approach allows for the estimation of the ...
-
A comparative study between NURBS surfaces and voxels to simulate the wear phenomenon in micro-EDM Article dans une revue avec comité de lecture; ;PERNOT, Jean-Philippe (CAD Solutions LLC (imprimé) and Taylor & Francis Online (en ligne), 2016)
The prediction of the tool wear phenomenon in the micro electro discharge machining technology would be of a great use in the optimization of tool shapes. In order to do so, the ability to rapidly and precisely simulate ...