Estimating the exchanged energy distribution in micro-EDM
Communication avec acte
Auteur
BIGOT, SamuelD'URSO, GianlucaMERLA, CristinaPEYROUTET, JérémySURLERAUX, Anthony 
PERNOT, Jean-PhilippeRésumé
This paper presents a new approach for the recording of the total quantity of energy exchanged during the micro Electro Discharge Machining (EDM) process. In particular, this approach allows for the estimation of the percentage of energy absorbed by the two electrodes (tool and workpiece) using a combination of theoretical models and experimental results, thanks to an advanced discharges measuring approach. The validity of several theoretical crater models was then assessed. Using this approach, the process was analysed for two electrode shapes and two sets of machining parameters. The preliminary results appears to fit those presented in the literature.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Documents liés
Visualiser des documents liés par titre, auteur, créateur et sujet.
-
Article dans une revue avec comité de lecture; ; ; ;PERNOT, Jean-Philippe (Elsevier, 2016)
This paper presents a new approach for the recording of the total quantity of energy exchanged during the micro electrical discharge machining (EDM) process. In particular, this approach allows for the estimation of the ...
-
Communication avec acte; ; ; ;PERNOT, Jean-Philippe (2015)
The present paper introduces the use of voxels embedded in an octree structure in order to numerically simulate manufacturing processes. In particular, micro electrical discharge machining (μEDM) is used here as a case ...
-
Article dans une revue avec comité de lecture; ; ;PERNOT, Jean-Philippe (Future Technology Press, 2015)
This paper describes a new efficient method for computer aided optimisations of micro EDM die sinking tools, which can be used for design optimisation and performance verification in the digital domain. This would facilitate ...
-
Article dans une revue avec comité de lecture; ; ;PERNOT, Jean-Philippe (Springer Verlag, 2016)
This paper introduces a new method for simulat- ing the micro-EDM process in order to predict both the tool’s wear and the workpiece’s roughness. The tool and workpiece are de ned by NURBS patches whose shapes result from ...
-
Communication avec acte; ; ;PERNOT, Jean-Philippe (2013)
This paper introduces a new method for simulating the micro-EDM process in order to predict tool wear. The tool and workpiece are defined by NURBS surfaces whose shapes result from an iterative crater-by-crater deformation ...