Nos laboratoires: Soumissions récentes
Voici les éléments 2542-2548 de 6547
-
Article dans une revue avec comité de lecture; ; ;
ROBINET, Jean-Christophe (American Physical Society, 2020)
The modal and nonmodal linear stability of a stably stratified Blasius boundary layer flow, composed of a velocity and a thermal boundary layer, is investigated. The temporal and spatial linear stability of such flow is ... -
Article dans une revue avec comité de lecture; ; ; ;SKALLI, Wafa; ; VERGARI, Claudio (Springer Verlag, 2020)
Purpose The origin of the deformity due to adolescent idiopathic scoliosis (AIS) is not known, but mechanical instability of the spine could be involved in its progression. Spine slenderness (the ratio of vertebral height ...
-
Article dans une revue avec comité de lecture(Springer Verlag, 2018)Purpose The global appearance of scoliosis in the horizontal plane is not really known. Therefore, the aims of this study were to analyze scoliosis in the horizontal plane using vertebral vectors in two patients classified ...
-
Article dans une revue avec comité de lecture; ; ; ;MONTEIRO, Eric (Wiley-Blackwell, 2020)
The mechanical behavior of polyethylene terephthalate (PET) under the severe loading conditions of the injection stretch blow molding process is strongly dependent on strain rate, strain, and temperature. In this process, ...
-
Demagnetization analysis of an open-end windings 5-phase PMSM under transistor short-circuit fault Communication avec acte;NGUYEN, Ngac Ky; SEMAIL, Eric (IEEE, 2019)
For an open-end windings integrated Permanent Magnet Synchronous Machine, the demagnetization of the permanent magnets is analyzed when a transistor is short-circuited and no specific control strategy is adopted. Depending ...
-
Communication avec acte;NGUYEN, Ngac Ky; SEMAIL, Eric (2020)
This paper proposes a new sensorless control strategy based on a Sliding Mode Observer (SMO) for a non-sinusoidal seven phase PMSMs. This strategy, based on all harmonics contained in the back-EMF, is compared to the ...
-
Article dans une revue avec comité de lecture; ;JACQUET, Philippe; ; ; NOUVEAU, Corinne (Wiley-VCH Verlag, 2019)
In this article the results concerned influence of processing conditions of the wire electrical discharge machining and vibro‐abrasive machining on the surface layer and morphology of samples made of hard machinable materials ...
