Mechanical characterization and modelling of Inconel 718 material behavior for machining process assessment
TypeArticles dans des revues avec comité de lecture
Articles dans des revues avec comité de lecture
Nickel based alloys are extensively used in the aerospace industry due to the excellent corrosion resistance and high mechanical properties that are maintained up to elevated temperatures (600–800 °C). However, these superalloys are classified as difficult-to-cut and therefore modelling and simulation of the machining processes has become a key in the machinability assessment of nickel based alloys. The reliability of Finite Element Models (FEM) largely depends on the quality of input parameters, one of the most relevant being the constitutive material model representing work material behavior under high strain, strain rate and temperatures. In order to develop a reliable material model, the present work deals with a complete characterization of Inconel 718. Uniaxial compression tests at testing temperatures close to those found in machining (21–1050 °C) and high strain rates (10°−10 2 s −1 ) were performed on the Gleeble 3500 testing machine. Moreover, the microstructural analysis and microhardness measurements of the testing samples were performed, in order to correlate the microstructural state with the mechanical properties of the Inconel 718. Based on this experimental work, a new coupled empirical model is proposed to describe the particular behaviour of nickel based alloys at elevated temperatures and high strain rates. This material behaviour model introduces softening phenomena as well as the coupling between the temperature and the strain rate known to occur experimentally, for machining FEM simulations with Inconel 718 superalloy.
Showing items related by title, author, creator and subject.
Corrigendum to “Mechanical characterization and modelling of Inconel 718 material behavior for machining process assessment” [Mater. Sci. Eng. A 682 (2017) 441–453] ITURBE, Ariane; GIRAUD, Eliane; HORMAETXE, Exabier; GARAY, Ainhara; GERMAIN, Guénaël; OSTOLAZA, Koldo; ARRAZOLA, Pedro José (Elsevier BV, 2019-05)Corrigendum to “Mechanical characterization and modelling of Inconel 718 material behavior for machining process assessment” [Mater. Sci. Eng. A 682 (2017) 441–453]
GIRAUD, Eliane; ROSSI, Frédéric; GERMAIN, Guénaël; OUTEIRO, José (Elsevier, 2013)The success of a FE model for metal cutting process is strongly dependent on the accurate characterization of the workpiece material, under similar conditions as those found in metal cutting. In this paper, dynamic shear ...
DAL SANTO, Philippe; GERMAIN, Guénaël; BOUDE, Serge; GIRAUD, Eliane (Taylor and Francis, 2014)In this article, the development of an industrial prototype for manufacturing aeronautical fuselage panels is investigated. Deep drawing of large components such as aircraft fuselage panels is not an easy task in terms of ...
Process Mechanics and Surface Integrity Induced by Dry and Cryogenic Machining of AZ31B-O Magnesium Alloy OUTEIRO, José; ROSSI, Frédéric; FROMENTIN, Guillaume; POULACHON, Gérard; GERMAIN, Guénaël; BATISTA, Antonio (Elsevier, 2013)The corrosion resistance of magnesium alloys depends mainly on its surface integrity. Previous experimental studies have shown that machining can induces small (nano-scale) grain size, compressive residual stresses and ...
GIRAUD, Eliane; PACE, Sergio; LECOMTE-BECKERS, Jacqueline (Kaunas University of Technology, 2014)The aim of this work was to determine the ability to produce thin metallic foils by self-induced ion plating. Foils of pure copper and pure zinc with a thickness of 35 μm have been successfully produced and their characteristics ...