Modelling wooden cultural heritage. The need to consider each artefact as unique as illustrated by the Cannone violin
TypeArticles dans des revues avec comité de lecture
This research work investigates the possibility to use a hygroscopic model based on Fick’s law to predict the global moisture content variations an historical violin undergoes during a concert. To set up the model to work some input are required such as: the object geometries, the wood species used, the thicknesses, the moisture diffusion coefficients, the permeability of varnished surfaces, the anhydrous masses of the moisture exchanging parts, the sorption isotherms, information often far from being available or measurable. At a first extent, the model was run on the environmental conditions recorded during nine concerts played with the “Cannone” violin (1743) and the computed mass variations compared with the mass variations recorded during the same concerts. The model, set with simplifying conditions and with diffusion coefficients from literature, has shown a very little predictive capacity. On the other hand, the model was tuned on the experimental data using an inverse procedure for moisture diffusion coefficient identification. After the tuning the model has shown a very good predictive ability showing how Fick’s low can be profitably used to assess the mass transfer in a complex heritage object such as a violin. This paper highlights the possibility to successfully use the Fick’s law to model mass transfer in a violin but also makes evident how such models must be tuned with real measurements in order to be effective.
Fichier(s) constituant cette publication
Cette publication figure dans le(s) laboratoire(s) suivant(s)
Visualiser des documents liés par titre, auteur, créateur et sujet.
Specific Cutting Forces of Isotropic and Orthotropic Engineered Wood Products by Round Shape Machining GOLI, Giacomo; CURTI, Rémi; MARCON, Bertrand; SCIPPA, Antonio; CAMPATELLI, Gianni; FURFERI, Rocco; DENAUD, Louis (MDPI AG, 2018)The set-up of machining parameters for non-ferric materials such as wood and wood-based materials is not yet defined on a scientific basis. In this paper, a new rapid experimental method to assess the specific cutting ...
MARCON, Bertrand; GOLI, Giacomo; MATSUO-UEDA, MIYUKI; DENAUD, Louis; UMEMURA, Kenji; GRIL, Joseph; KAWAI, Shuichi (SISEF (Italian Society of Silviculture and Forest Ecology), 2018)The kinetics of several poplar (Populus alba L.) wood properties during thermal modification conducted in conventional oven with air recirculation were analysed and modelled in this paper. A wide range of properties was ...
YOUSFI, Mohammed; OUTEIRO, José; NOUVEAU, Corinne; MARCON, Bertrand; ZOUHAIR, Badr (Elsevier, 2017)Cryogenic assistance is used to improve machining performance and to enhance tool life under extreme contact conditions (pressure and temperature). This paper focuses on the influence of cryogenic cooling conditions using ...
Phenomenological study of multivariable effects on exit burr criteria during orthogonal cutting of AlSi alloys using principal components analysis RÉGNIER, Tristan; FROMENTIN, Guillaume; D'ACUNTO, Alain; OUTEIRO, José; MARCON, Bertrand; CROLET, Arnaud (ASME American Society of Mechanical Engineers, 2018)During machining, burrs are produced along a part’s edges, which can affect a final product lifetime or its efficiency. Moreover, time-consuming and expensive techniques are needed to be applied to remove such burrs. ...
CURTI, Rémi; MARCON, Bertrand; DENAUD, Louis; COLLET, Robert (BioResources, 2018)Proper valorization of the sawing wastes in industrial sawmills is a permanent issue with strong economic and environmental stakes. Most industrial sawmills are equipped with chipper-canter heads reducing the outer part ...