Investigations on drilling performance of high resistant austenitic stainless steel
Article dans une revue avec comité de lecture
Author
ARIF, RabiaeFROMENTIN, GuillaumeROSSI, FrédéricMARCON, BertrandAbstract
The aim of the investigations presented in this research work is to optimize the cutting geometry for drilling of Heat Resistant Austenitic Stainless Steel (HRASS) based on the tool life and strain hardening generated on the work material during cutting process. In particular, an attempt has been made to understand the effect of cutting edge preparation on both the cutting forces and the strain hardening of the work material. Besides, chips in flutes are also analyzed by tomography technique to better understand their evacuation in-situ in correlation with the cutting forces. A Quick-Stop Device (QSD) in drilling is also employed to analyze the influence of the cutting edge radius, the coating material, and the cutting fluid nature on the strain hardened layer using micro hardness filiations.
Files in this item
Collections
Related items
Showing items related by title, author, creator and subject.
-
Communication avec acte(Elsevier, 2018)Machining of difficult-to-cut-materials like heat resistant stainless steels leads to the rapid tool wear and tool failure. The analysis of drilling process of these steels is even more difficult as it is not easy to ...
-
Article dans une revue avec comité de lecture(Springer Verlag, 2019)In the present research work, mechanical aspect of transient state in drilling operation is investigated by analyzing together the cutting forces and the chip formation. Particularly, a sudden peak occurring on cutting ...
-
Article dans une revue avec comité de lecture(American Society of Mechanical Engineers, 2020)This study presents a novel analysis of the machined subsurface layer formation dealing with strain hardening phenomenon which results from complex mechanisms due to cutting edge multiple passes in drilling. On the one ...
-
Article dans une revue avec comité de lecture(Elsevier, 2017)Ti-6Al-4V is commonly used especially in aerospace and biomedical industries. This alloy is known as a difficult-to-cut material. Due to its poor thermal properties, the heat generated during machining processes traps near ...
-
Article dans une revue avec comité de lecture(MM Publishing, s.r.o., 2021)To reduce the size of exit burrs induced by broaching, it is possible to use a low value martyred part clamped to the functional one on the tool exit side. Thence, this research work deals with an in-situ analysis of the ...