Laboratoire des Matériaux et Procédés (LaBoMaP): Recent submissions
Now showing items 295-301 of 382
-
Article dans une revue avec comité de lecture
MARTINS DO OUTEIRO, Jose Carlos; ; MARQUES, Maria José (Trans Tech Publications, 2014)
The major challenge of the Mg alloys has been their unsatisfactory corrosion resistance, which can be enhanced by improving the surface integrity. Cryogenic machining, where liquid nitrogen was used during machining, has ... -
Article dans une revue avec comité de lectureMARTINS DO OUTEIRO, Jose Carlos (Inderscience, 2014)
Surface integrity (SI) plays a very important role in functional performance. It is dependent on a large number of machining parameters. The major concern of industry is to know which combination of machining parameters ...
-
Communication avec acteCARUSO, SERAFINO; MARTINS DO OUTEIRO, Jose Carlos; ; (Trans Tech Publications, 2014)
Residual stress is one of the most important surface integrity parameter that can significantly affect the service performance of a mechanical component, such as: contact fatigue, corrosion resistance and part distortion. ...
-
Communication avec acte; ; ;DENAUD, Louis (2013)
France is poplar largest producer in Europe. Most of companies have a very specialized raw material supply chain since they use almost one type of cultivar for their specific products. For example, I-214 is very suitable ...
-
Article dans une revue avec comité de lecture; ; ; ; ; ; ;COLLET, Robert (Universidad del Bío-Bío, 2015)
Wood heat treatment is an attractive alternative to improve decay resistance of wood species with low natural durability. However, this improvement of durability is realized at the expense of the mechanical resistance. ...
-
Article dans une revue avec comité de lecture;BESNARD, Aurélien; ; ; NOUVEAU, Corinne (American Institute of Physics, 2008)
Titanium oxide thin films were prepared by reactive magnetron sputtering. The reactive gas pulsing process was implemented to control the oxygen injection in the deposition process and,consequently, to tune the oxygen ...
-
Communication avec acte; ; ;MARQUES, Maria José; MARTINS DO OUTEIRO, Jose Carlos (2008)
Machinability enhancement of hot work tool steels can be achieved intrinsically through tailoring of alloying elements and steel processing route but also externally through the use of adequate tooling. The aim of the ...
