Laboratoire Procédés et Ingénierie en Mécanique et Matériaux (PIMM): Soumissions récentes

Voici les éléments 1142-1148 de 1302

    • Statistical identification of geometric parameters for high speed train catenary 
      Communication avec acte
      VO VAN, Olivier; BALMES, Etienne; MASSAT, Jean-Pierre (KUL, 2014)
      Pantograph/catenary interaction is known to be strongly dependent on the static geometry of the catenary, this research thus seeks to build a statistical model of this geometry. Sensitivity analyses provide a selection of ...
    • Effects of temperature on the impedance of piezoelectric actuators used for SHM 
      Communication avec acte
      BALMES, Etienne; ccMECHBAL, Nazih; ccGUSKOV, Mikhail; ccRÉBILLAT, Marc (Vishno, 2014)
      — FEM modeling of piezoelectric patches used as actuators and sensors for SHM applications. — Test/analysis correlation of temperature effects in piezoelectric materials and glue — Numerical methods associated with the ...
    • Méthode de vieillissement accéléré au dioxyde de chlore 
      Article dans une revue avec comité de lecture
      DAUSEINS, J; EL MAZRY, Chaker; MALLET, J; CORREC, Olivier; ccCOLIN, Xavier (ASTEE/EDP Sciences, 2014)
      With the aim to study the long-term behavior of accessories used in the tap domestic water supply system, the Centre scientifique et technique du bâtiment (CSTB) has developed a tool dedicated to accelerated ageing tests ...
    • Assessment of low cycle fatigue improvement of machined AISI 316 stainless steel by brush hammering 
      Article dans une revue avec comité de lecture
      SIDHOM, Naziha; MAKHLOUF, Kamel; KHLIFI, Ammar; SIDHOM, Habib; ccBRAHAM, Chedly (Wiley-Blackwell, 2014)
      The effects of wire brush hammering on low cycle fatigue behaviour of AISI 316 austenitic stainless steel has been investigated on turned samples through an experimental study combining strain controlled fatigue tests, ...
    • Study of the response of CFRP composite laminates to a laser-induced shock 
      Article dans une revue avec comité de lecture
      GAY, Elise; BERTHE, Laurent; BOUSTIE, Michel; ARRIGONI, Michel; MARION, Trombini (Elsevier, 2014)
      Laser-induced shock yields to a local tensile stress within a sample. This high strain rate stress can be used to verify the bond strength between two layers. This method has been applied to Carbon Fibre Reinforced Polymer ...
    • Role of strain induced crystallization and oxidative crosslinking in fracture properties of rubbers 
      Article dans une revue avec comité de lecture
      LE GAC, Pierre Yves; BROUDIN, Morgane; ROUX, Gérard; VERDU, Jacques; DAVIES, Peter; ccFAYOLLE, Bruno (Elsevier, 2014)
      Tensile properties and crack propagation properties, especially critical strain energy release rate in mode I, GIC, have been used to investigate fracture properties of elastomers and their relationships with microstructure. ...
    • Chain branching detection by Cole–Cole modeling of rheological properties changes during PET mechanical recycling 
      Article dans une revue avec comité de lecture
      NAIT-ALI, K.L.; BERGERET, A; FERRY, L; ccCOLIN, Xavier (Elsevier, 2012)
      The detection of branched chains in thermally degraded thermoplastic polymers is far from simple, especially at a low conversion ratio, mainly because of the low sensitivity of commonly used laboratory analytical techniques. ...