Laboratoire Procédés et Ingénierie en Mécanique et Matériaux (PIMM): Soumissions récentes
Voici les éléments 526-532 de 1306
-
Article dans une revue avec comité de lecture; ;
FAVIER, Véronique (Elsevier, 2010)
This work investigates a new micromechanical modeling of polycrystal plasticity, accounting slip bands for physical plastic heterogeneities considered as periodically distributed within grains. These intra-granular plastic ... -
Article dans une revue avec comité de lecture; ;REGNIER, Gilles; CHINESTA SORIA, Francisco (Springer Verlag, 2010)
Commonly isolated carbon nanotubes in suspension have been modelled as a perfectly straight structure. Nevertheless, single-wall carbon nanotubes (SWNTs) contain naturally side-wall defects and, in consequence, natural ...
-
Article dans une revue avec comité de lecture(Elsevier, 2010)Tin-zinc alloy electroplated coatings are recognized as a potential alternative to toxic cadmium as corrosion resistant deposits because they combine the barrier protection of tin with the cathodic protection afforded by ...
-
Article dans une revue avec comité de lecture(Elsevier, 2010)χ-, κ- and α-alumina phases formed by dehydration of micro-grained gibbsite between 773 and 1573 K are studied using infrared spectroscopy (IR). The structural transitions evidenced by X-ray diffraction (XRD) were interpreted ...
-
Article dans une revue avec comité de lecture; ;COLIN, Xavier; RICHAUD, Emmanuel (Elsevier, 2010)
A non-empirical kinetic model has been built for describing the general trends of radiooxidation kinetics of ethylene-propylene copolymers (EPR) at low γ dose rate and low temperature. It is derived from a radical chain ...
-
Article dans une revue avec comité de lecture(Elsevier, 2010)A carbon-black filled SBR was submitted to various uniaxial tension cyclic tests in order to study its cyclic softening. Stress-softening and stretch creep were monitored during stretch-control tests and ratcheting tests, ...
-
Article dans une revue avec comité de lecture; ; ; ; ;FAYOLLE, Bruno (Elsevier, 2011)
In order to characterize the mechanical behavior of HDPE pipes, the ASTM D 2290-04 standard recommends carrying out tensile tests on notched rings, cut out from the pipe. This very simple test is also utilized to investigate ...
