Laboratoire Procédés et Ingénierie en Mécanique et Matériaux (PIMM): Soumissions récentes
Voici les éléments 995-1001 de 1243
-
Article dans une revue avec comité de lecture;
GUSKOV, Mikhail (American Society of Mechanical Engineers, 2012)
Quasi-periodic motions and their stability are addressed from the point of view of different harmonic balance-based approaches. Two numerical methods are used: a generalized multidimensional version of harmonic balance and ... -
Article dans une revue avec comité de lecture; ; ;TCHARKHTCHI, Abbas (Wiley, 2012)
Fatigue damage initiation of a PA66/glass fiber composite material is studied with interrupted tests carried out with an “alternative bending device” and a small applied strain. During the damage initiation period, no ...
-
Article dans une revue avec comité de lecture(2015)This research deals with an experimental and micromechanical study of high rate recycled asphalt with 70% of RAP. Rheological measurements of shear complex modulus of virgin, RAP and blended binders were performed at ...
-
Article dans une revue avec comité de lecture; ; ; ;BRAHAM, Chedly (Elsevier, 2015)
Recent studies in computational weld mechanics have revealed the importance of the material plasticity model when predicting weld residual stresses. The present work seeks to extend this level of understanding to include ...
-
Article dans une revue avec comité de lecture; ; ;RICHAUD, Emmanuel (Wiley, 2015)
The kinetic model, established in a previous article (François-Heude et al., J. Appl. Polym. Sci., in press) to predict the homogeneous oxidation in iPP films typically thinner than 100 µm, is now extended to simulate the ...
-
Article dans une revue avec comité de lecture(Springer Verlag, 2015)A theoretical approach based on a numerical simulation using experimental data is proposed as a contribution for the study of laser metal cutting under gas assistance. The aim is to simulate the stages of the kerf formation ...
-
Article dans une revue avec comité de lecture(Laser Institute of America, 2015)It has been observed that the penetration depth during laser welding (LW) under vacuum or reduced ambient pressure could be significantly greater than that during welding under atmospheric pressure. Previous explanations ...
