Laboratoire Procédés et Ingénierie en Mécanique et Matériaux (PIMM): Recent submissions

Now showing items 1079-1085 of 1302

    • Pantograph catenary dynamic optimisation based on advanced multibody and finite element co-simulation tools 
      Article dans une revue avec comité de lecture
      MASSAT, Jean-Pierre; LAURENT, Christophe; BIANCHI, Jean-Philippe; BALMES, Etienne (Taylor & Francis, 2014)
      This paper presents recent developments undertaken by SNCF Innovation & Research Department on numerical modelling of pantograph catenary interaction. It aims at describing an efficient co-simulation process between Finite ...
    • On some aspects of the CNEM implementation in 3D in order to simulate high speed machining or shearing 
      Article dans une revue avec comité de lecture
      ILLOUL, Lounès; ccLORONG, Philippe (Elsevier, 2011)
      his paper deals with the implementation in 3D of the constrained natural element method (CNEM) in order to simulate material forming involving large strains. The CNEM is a member of the large family of mesh-free methods, ...
    • Dissipation Assessments During Dynamic Very High Cycle Fatigue Tests 
      Article dans une revue avec comité de lecture
      BLANCHE, Antoine; CHRYSOCHOOS, André; ccRANC, Nicolas; ccFAVIER, Véronique (Society for Experimental Mechanics, 2015)
      This paper presents an experimental device developed to detect and estimate dissipated energy during very high cycle fatigue tests (VHCF) at high loading frequency (20 kHz) and low stress (i.e. far below the yield stress). ...
    • Effect of the Mullins softening on mode I fracture of carbon-black filled rubbers 
      Article dans une revue avec comité de lecture
      DIANI, Julie; BRIEU, Mathias; BATZLER, Katharina; ZERLAUTH, Pierre (Springer Verlag, 2015)
      The effect of the Mullins softening on mode I fracture of carbon-black filled rubbers was investigated experimentally. Large specimen of NR and SBR filled with the same amount and nature of carbon-black were submitted to ...
    • Dynamic Study of Thin Wall Part Turning 
      Communication avec acte
      LARUE, Arnaud; PERE-DUARTE, Alexis; ccLORONG, Philippe (2011)
      The numerical simulation of machining process is a key factor in the control of parts machining process. Its development aims at improving the process reliability and reduces the time spent during the process planning ...
    • Application of a Combined Active Control and Fault Detection Scheme to an Active Composite Flexible Structure. 
      Article dans une revue avec comité de lecture
      VERGÉ, Michel; COFFIGNAL, Gérard; GANAPATHI, Manickam; ccMECHBAL, Nazih (Elsevier, 2006)
      In this paper, the problem of increasing reliability of active control procedure is considered. Indeed, a design method of rejection perturbation in presence of potentially faults, on a flexible structure with integrated ...
    • Introduction of variability into pantograph–catenary dynamic simulations 
      Article dans une revue avec comité de lecture
      VO VAN, Olivier; MASSAT, Jean-Pierre; LAURENT, Christophe; BALMES, Etienne (Taylor & Francis, 2014)
      Currently, pantograph-catenary dynamic simulations are mainly based on deterministic approaches. However, the contact force between catenary and pantograph depends on many key parameters that are not always quantified ...